R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: pizzaboy192
Showing results 1 to 25 of 87
Search took 0.01 seconds.
Forum: Electric On-Road
12-05-2014, 09:31 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

If you're going to do this, don't try a race with...

If you're going to do this, don't try a race with fresh gum. Let it sit for a little while (6+ hours) for very solid gearbox. You can run it for a short while to get the gum in the whole set of...
Forum: Electric On-Road
12-05-2014, 08:57 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

One thing I've used is chewed chewing gum. Some...

One thing I've used is chewed chewing gum. Some of the stuff that is "long lasting" or known for not turning to chalk after chewing it after a few minutes. It'll get pliable with heat, but isn't...
Forum: Electric On-Road
11-21-2014, 02:09 PM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Hi all. Finally got my m03 back into running...

Hi all. Finally got my m03 back into running condition after replacing some rusted parts. I've run into a new issue since upgrading to LiPo. My car just will not connect to any surface I run it on....
Forum: Electric On-Road
11-17-2014, 01:39 PM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

No hits on Google, Bing, or eBay. Is there an...

No hits on Google, Bing, or eBay. Is there an alternate part number?
Forum: Electric On-Road
11-17-2014, 10:07 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Is there a source for the two long screws that...

Is there a source for the two long screws that hold the rear lower suspension to the chassis on the M03? (No idea what the right term for it is)

I ran my M03 in snow last winter and the snow +...
Forum: Radio and Electronics
11-17-2014, 06:03 AM
Replies: 141
Views: 184,579
Posted By pizzaboy192

I would assume that you could set dual-rate to be...

I would assume that you could set dual-rate to be 0%\100% if it allows that option, or when the manufacturer gets back to you on how to configure it properly.
Forum: Radio and Electronics
11-16-2014, 05:19 PM
Replies: 141
Views: 184,579
Posted By pizzaboy192

The manual says that it can operate in single...

The manual says that it can operate in single rate mode (only 1 setting, always on) or dual-rate mode (One setting when CH3 inactive, alternate setting when CH3 active) if you connect the plug. It...
Forum: Electric On-Road
09-02-2014, 07:26 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

2 quick questions: Is M03 still TCS Legal? &...

2 quick questions: Is M03 still TCS Legal? & Anyone want an M03 roller? Wife says I have to sell some stuff if I want to buy new stuff, so the spare 03 is on the block =\
Forum: Electric On-Road
06-29-2014, 02:42 PM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Just the cups! I've never shattered an end, but...

Just the cups! I've never shattered an end, but those plastics seem to break easily =(
Forum: Electric On-Road
06-22-2014, 03:41 PM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

I am having such a difficult time finding...

I am having such a difficult time finding affordable M03 turnbuckle ends. I snapped one one My M03 and one on the wife's. Would ones for a TA04 or a DT03 fit it? I'm not trying to be TCS legal, just...
Forum: Electric On-Road
06-06-2014, 07:04 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Good to know. I'm prepping an M03 and a TA03F for...

Good to know. I'm prepping an M03 and a TA03F for rally racing this fall and need something with longer runtimes than my 2000mAh NIMH packs when running a 15turn.
Forum: Electric On-Road
06-06-2014, 06:49 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Does it at least fit in an M03 or would it be...

Does it at least fit in an M03 or would it be better to get a rounded LiPo pack?
Forum: Electric On-Road
05-05-2014, 07:50 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

My experience is mainly with the M03, but I can...

My experience is mainly with the M03, but I can do you one better and show you how to snowproof your M chassis. Here's a pic of my M03 coated in snow. http://i.imgur.com/jIdUfGo.jpg

Here's what I...
Forum: Electric On-Road
04-09-2014, 06:59 PM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

For anyone switching to the M05V2 and ditching...

For anyone switching to the M05V2 and ditching their stick-pack LiPo batteries: I'm open for purchasing the used ones. My TA03 and M03 will love them =D
Forum: Electric On-Road
04-01-2014, 02:59 PM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Assuming this isn't an April 1st joke, would you...

Assuming this isn't an April 1st joke, would you be against me hosting a mirror on my site for anyone who wants to enjoy the Rc-Mini knowledge after the website goes dark?
Forum: Electric On-Road
03-22-2014, 10:05 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Check your ESC's calibration. I know that my...

Check your ESC's calibration. I know that my M03's seemed to have one faster than the other, but it turned out that one of my ESCs were mis-calibrated, so I was only getting 80% of the max power out...
Forum: R/C Items: For Sale/Trade
03-20-2014, 05:55 PM
Replies: 1
Views: 796
Posted By pizzaboy192

Tamiya TA03F roller, TA03R roller, TA03RS kit parts, Novak GT7 ESC

So I had purchased all of this to be a fun project while I was away from my fiancee... but the same day I got the entirety of the stuff, life finds a way to get you to bend over and steal your...
Forum: Radio and Electronics
03-16-2014, 04:09 PM
Replies: 141
Views: 184,579
Posted By pizzaboy192

I did the same thing. You have to wire up the...

I did the same thing. You have to wire up the programmer differently, but it works amazingly well. Was able to read the FW from my radio, but I was using staples instead of a pin header, and wasn't...
Forum: Electric On-Road
03-10-2014, 09:48 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

I've tried the graphite lock lube and it works...

I've tried the graphite lock lube and it works really well, but you need to avoid getting it into your motor or it'll kill it. Silicone spray or electronics cleaner work well too. The M03 has the...
Forum: Electric On-Road
03-02-2014, 07:38 PM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

Has anyone had success running a Tamiya TA03-RS...

Has anyone had success running a Tamiya TA03-RS with a LWB M03\05 body? Does it work, or would it be better to get regular TC bodies?
Forum: R/C Items: For Sale/Trade
03-02-2014, 04:02 PM
Replies: 13
Views: 1,605
Posted By pizzaboy192

So it's just add servo, Rx, motor, and ESC,...

So it's just add servo, Rx, motor, and ESC, correct? Any suggestions on a servo for it?
Forum: Nebraska/Iowa Racing
02-13-2014, 12:13 PM
Replies: 5,238
Views: 570,974
Posted By pizzaboy192

Does the charger support Lipo? I shoulda looked...

Does the charger support Lipo?
I shoulda looked at the picture. Does it come with a DC power source, or do I have to source my own?
Forum: Electric On-Road
02-04-2014, 08:56 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

From what I understand, the silvercans won't be...

From what I understand, the silvercans won't be disallowed, but they're opening up the options for brushless as well. If you don't want to drop $200 on a new motor setup, then don't.
Forum: Electric On-Road
02-04-2014, 08:36 AM
Replies: 29,987
Views: 4,956,494
Posted By pizzaboy192

I'll have to see what results I get then. I have...

I'll have to see what results I get then. I have a few silvercans that I got from a local racer, along with my Trinity SlotMachineII that is supposedly ROAR approved and since I replaced the brushes...
Showing results 1 to 25 of 87
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.