R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: vassago
Showing results 1 to 25 of 177
Search took 0.01 seconds.
Forum: Electric On-Road
06-06-2012, 09:13 AM
Replies: 4,798
Views: 882,853
Posted By vassago

Any setup sheets from the ETS to share? Would...

Any setup sheets from the ETS to share?
Would like a stock one but I'll take Hara's or Moore's :)
Forum: Electric On-Road
05-17-2010, 05:18 AM
Replies: 4,798
Views: 882,853
Posted By vassago

We are talking about the TCX aren't we?...

We are talking about the TCX aren't we? :rolleyes:

Do you really expect them to nearly double the price for a new kit?
Forum: Electric On-Road
05-17-2010, 03:50 AM
Replies: 4,798
Views: 882,853
Posted By vassago

I doubt that price is correct, RC Champ quoted me...

I doubt that price is correct, RC Champ quoted me 41600 Yen which is pretty reasonable.
Forum: Electric On-Road
05-11-2010, 03:51 AM
Replies: 23,359
Views: 2,661,839
Posted By vassago

With the x12 10.5 / 13.5 it is a good idea to use...

With the x12 10.5 / 13.5 it is a good idea to use the timing insert with the least timing and time with the ESC.
(IIRC the 4 dot timing insert)

Otherwise the motor will get very hot indeed.
Forum: Electric On-Road
04-21-2010, 01:41 AM
Replies: 19,761
Views: 1,976,044
Posted By vassago

This... Check uptravel without shocks, if it...

This...

Check uptravel without shocks, if it is even than you have found the issue.
Most likely it is the shocks.
Forum: Electric On-Road
04-20-2010, 08:27 AM
Replies: 19,761
Views: 1,976,044
Posted By vassago

On the Cyclone you can also tighten the diff in...

On the Cyclone you can also tighten the diff in the car, insert a small screwdriver or a long bodypin in the screw and turn the wheel. It's a bit fiddly but when you get the hang of it it's pretty...
Forum: Electric On-Road
12-18-2009, 03:21 AM
Replies: 19,761
Views: 1,976,044
Posted By vassago

You are right, quote from Artwork: "Someone...

You are right, quote from Artwork:

"Someone posted about this earlier...I think it is for one of the older cyclones and is not needed for the TC. You do however need the 2mm round shim that comes...
Forum: Electric On-Road
12-18-2009, 03:01 AM
Replies: 19,761
Views: 1,976,044
Posted By vassago

Lipo Topdeck set

I have just received my "#67695 - Li-Po Battery Upper Deck Conversion Set" and put it on my car.
However a small alu strip with 2 holes comes with it and I am stumped on where to put it.
Can...
Forum: Radio and Electronics
12-10-2009, 04:13 AM
Replies: 26
Views: 5,820
Posted By vassago

You can also send in the GFX 35 and get it...

You can also send in the GFX 35 and get it uptdate for LiPO.
(You'll still need an external balancer IIRC though)
Forum: Electric On-Road
05-07-2009, 04:42 AM
Replies: 1,461
Views: 149,633
Posted By vassago

I ran my HB Cyclone12 with the GTB, just removed...

I ran my HB Cyclone12 with the GTB, just removed the fan. NP with either stock or mod. motors on 4 cells.
If you don't trust it, just try it and watch the temperature.
Forum: Electric On-Road
04-30-2009, 05:11 AM
Replies: 4,165
Views: 740,056
Posted By vassago

Jaco front tires

I just switched from GRP fronts to Jaco fronts, but the Jacos seem to be a bit narrower so there is a lot of play between the nut and the wheel.
I used 4 shims to get that out, but there must be...
Forum: Electric On-Road
03-22-2009, 03:07 AM
Replies: 110
Views: 11,890
Posted By vassago

Could you explain how to open these packs the...

Could you explain how to open these packs the easiest way?

I have tested the Zippy's side by side with SMC 5000Mah 28C packs, voltage is about 7.1V as opposed to 7.2V for the SMC under 35A...
Forum: Radio and Electronics
09-18-2008, 06:28 AM
Replies: 1,312
Views: 213,608
Posted By vassago

Whenever I try to lessen available break with ATL...

Whenever I try to lessen available break with ATL or EPA my car starts to move forward instead. It looks like throttle center position is moved forward instead of just shortening brake throw.
...
Forum: Electric On-Road
09-15-2008, 02:20 AM
Replies: 197
Views: 29,717
Posted By vassago

KinzR, can you tell me what I need to run smaller...

KinzR, can you tell me what I need to run smaller front tires?
Can I just use the IRS lowered arm set or do I need other parts as well?
Forum: Electric On-Road
09-11-2008, 11:45 PM
Replies: 19,761
Views: 1,976,044
Posted By vassago

I tried it on the ground like Bigz said as well...

I tried it on the ground like Bigz said as well and it is a lot better indeed :)
(Never had the problemen with my Moore due to a different steering setup or any other car so was a bit surprised)
Forum: Electric On-Road
09-09-2008, 11:28 PM
Replies: 19,761
Views: 1,976,044
Posted By vassago

I was trying to finish my new Cyclone TC...

I was trying to finish my new Cyclone TC yesterday evening but I found 2 problems I was unable to resolve:

-The steering turnbuckles hit the pivot block when trying to steer.

-The plastic...
Forum: Electric On-Road
08-20-2007, 04:35 AM
Replies: 999
Views: 118,994
Posted By vassago

I suggest mailen Erik directy instead of using a...

I suggest mailen Erik directy instead of using a forum.
Check www.spintec.nl for contact adresses.

I am sure you will work something out.
Forum: Electric On-Road
08-15-2007, 06:20 AM
Replies: 1,523
Views: 164,831
Posted By vassago

Any will do, there is nothing going thru it...

Any will do, there is nothing going thru it anyways.
Forum: Electric On-Road
08-05-2007, 08:22 AM
Replies: 127
Views: 16,161
Posted By vassago

http://www.blogs.se/community/profile_photo_sizes....

http://www.blogs.se/community/profile_photo_sizes.php?item_ID=1853567&album_ID=237825

Does the new Xray come with different dampers or did the team finally decide the original ones do suck? :lol:
Forum: Electric On-Road
05-14-2007, 06:02 AM
Replies: 19,761
Views: 1,976,044
Posted By vassago

Don't think that will work, the bulkheads are...

Don't think that will work, the bulkheads are farther apart on the Cyclone than on the Xray.

You can use Xray CVDs in the front if you use a one-way, replace the HB one-way outdrives with Xrays...
Forum: Electric On-Road
05-10-2007, 11:43 PM
Replies: 26
Views: 2,354
Posted By vassago

Nothing to do with camber, there just is too much...

Nothing to do with camber, there just is too much room between the insert and the tire.

Put electricians tape on the rim before mounting the insert and tire and the ridge will be gone. (Grip will...
Forum: Electric On-Road
05-07-2007, 07:40 AM
Replies: 1,523
Views: 164,831
Posted By vassago

I _think_ there is a resistor between the 2 clips...

I _think_ there is a resistor between the 2 clips connecting the + and - of the 6th cell and a wire between cell 5 and 6. I can measure it when I get home.

Have you tried asking Eric by e-mailing...
Forum: Electric On-Road
04-30-2007, 07:06 AM
Replies: 360
Views: 44,729
Posted By vassago

One of the members on our club uses a similar...

One of the members on our club uses a similar setup, don't know which radio though. You can use steering and throttle on the same stick so you can control the car with one hand. (like using a...
Forum: Electric On-Road
02-21-2007, 03:31 AM
Replies: 302
Views: 31,038
Posted By vassago

No need to test this, internally it only does...

No need to test this, internally it only does linear discharge for 5 cells of course.

If you want the pulse discharge you need to do that externally.
Forum: Electric On-Road
02-17-2007, 11:07 PM
Replies: 302
Views: 31,038
Posted By vassago

http://img149.imageshack.us/img149/3840/img0151hm6...

http://img149.imageshack.us/img149/3840/img0151hm6.jpg

;)

Works perfect.
Showing results 1 to 25 of 177
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.