Been running gt2.0 pro in my 4wd sc trinity 4800 4pole. and it's super smooth.
I left it in the stock no timing mode just calibrated.*
And it's been working great till today. I tq'd 4wd shortcourse and went out for my main and did 1 lap and it shut down. Changed out lipos none will work and I dnf'ed. Motor has been running fine 160ish temps esc 110 or so fan intact and running always.

All the esc will do is flash a red light no throttle input tried 2 receivers as well.*
Sometimes I will get power to motor but will run random even without input from transmitter.

Any ideas on what I can do?
Do you repair them?

Bought from us how can I get an rma?

Howard, when do you expect the "Blaze" 550 motors, also the website shows them paired with Reventon "R" esc's. Is this accurate, for 4wd, and not the "Pro"

I'll have my Reventon "R" 's in silver tomorrow. I have my Bluetooth module already.

My new toys...





I also have the bluetooth module too.

Nice raul.....let us know how it does

That programming box is huge! That screen and buttons would suggest something the quarter of its size, why is it not smaller? Maybe a development prototype?

is this the last box they made that had the squishy buttons? I remember when they switched boxes from the HW style one to a newer one but the main complaint was the feel of the buttons.

Can your old programmer boxes be used on the Revention?

I have read where the Revention S is aimed at spec/blinky racing. I am looking at running Stock 2wd 17.5 Blinky. Now locally they also run a 13.5 class with non blinky settings. Would the S cover me on both of those classes?

I was told that the Revention S can handle up to a 9.5 so you should be more than fine.

Clint will do.

Cain, the buttons are rigid.


DTR,
the box looks so big because the speedo is so small..

Well, tonight I had the opportunity to wire up my Reenton "R" speedo, and setup the Wi-fi module for Apple devices. I must say I am pretty impressed so far.

Hi is the Speed Passion MMM 17.5r motor good? Does it overheat? I will be running it in 17.5 blinky.

I have a Speed Passion LPF ESC with an orion Vortex 17.5 motor a Spektrum 6010 servo and a SR300 RX and DX2S TX.

When I go to give power I loose steering I added a capicitor to the RX and it worked for about 4 runs and it did it again last night in my A main club race that I was running third in and was ready to catch and pass second. Any ideas what would be causing this?

Great motor. I ran one in my buggy sevreral weeks ago. TQ'd at a pretty big event on a large outdoor 1/8 track. Just gear it right. I think I had it 75/32 with minimal physical timing on motor.

forgot to mention i had my tekin rs in prior to this and never had this problem.

anyone?