With all wires connected

Hideeho
Interesting. I'll have to try hooking it back up & backing off the timing on the can. Maybe that is the issue, not a temp sensor in the motor. I'll let you know what I find.

Stock Reventon Pro Setup request:

Looking for a good blinky setup for a Reventon Pro in a B4.2. Revtech 17.5/standard rotor, geared 72/34.

Will any firmware blink if all esc timing is off? Coming from an RS Pro...it has a weird low-mid hit that I couldn't tune out with gearing or can timing.

Strange.


Totally random, what is your radio setting? I noticed that if I had anything other than a linear curve, it would also do strange things when i ran the GT 2.0 or LPF ESC. Waiting for a car to show up on Mon before I test the new REV S. in it.


MOmo

This is in a 4x4 SCT

I run a RX8 looking for a smoother ESC. I was going to get a GT2.0, but maybe a Revention Pro would be the better option. Anyone run these in their trucks?

Only Stock0 will blink.

question...on average how long does it take for a SP rep to get back to you by email when you send in an item for repair?
I have send a few emails to them with my RMA# and still have not heard back from anyone..
I know my item is there as I tracked it online..:(

Hideeho
They modified the layout of my track today, so I stopped off to run a pack & try it out. I also reconnected the sensor wire & took most of the timing out of my lrp (1 dot). It did exactly the same. Ran great, lacking power but smooth, for about 5 minutes & thermaled:flaming:. Motor was @ 108* & the ESC was @ 97* (per temp gun, not the card). I pulled the sensor wire & ran sensor less for the rest of the pack. The motor got to 130* & the ESC to 120* (again by temp gun, not card). It was actually smoother sensor less than w/ the 2nd wire only out, but it still clogged @ low speed & from a stop. I'm going to see if I can borrow a motor that is not an lrp, tekin, or viper & give that a try tomorrow. It's not looking good for me continuing to run an lrp motor though:(.

Got my Reventon Pro 13.5r combo kit yesterday and to be honest I wasn't that impressed by its built quality. IMHO it looks cheaper than an HW Ezrun, which as entry level goes is pretty solid. I'd expected a bit more from the Reventon-series. Hopefully it's performance won't disappoint!

:spidey:

Anyone above?

Seriously? I have 2 and feel the quality is very good. I've had Tekin, Novak, LRP and feel this is better that all of them. What exactly was wrong with it

I run the Reventon pro in my Durango 4wd with a 5.5 550 can.... It's very smooth.... Mod2 software

Thank you, do u think it would be ok for a heavier truck like the Tekno?

In your opinion is it worth switching from a RX8? I happy with the RX8, but always looking to improve.

Mainly the plastic base.

The plastic quality and molding looks inferior to what I am used to. Not hopeless, just not as good or clean.

I also have HW, Novak, Castle and Teking entry, mid and high level ESCs to compare with.

But...if it runs as expected, I'll ignore the base :nod:

I'd keep the RX8, great ESC. :spidey: