Yeah, I will try Mod2. Worst that can happen is a fire, right. :)

You have to turn the temp control off i never use it on my k1 and i wont use it on the Tekno.

Tried that, no worky. See the last sentence of my first paragraph.

I see. Lower your lipo cut off or just shut it off. I have been told the ESC works better with them off. Does it turn off on the Rev Pro?

I have a feeling that your motor has the over heat protection on the sensor...can you disable one of the cable on the sensor wire and give that a try....? See below link for the wire that you need to cut...

http://www.speedpassion.net/files/So...eventonPro.pdf

I've just got the wifi module and am having problems connecting it to my iPhone 4S ( but no problems connecting it to my I pad) it will connect to it but not receive a wifi signal. Any ideas chaps?

Go to settings and manually choose the wifi network.

I can choose the network and connect to it but do not receive a wifi signal, no problems with the I pad just the phone

Hideeho
One of the videos had a guy entering the static ip as 192.168.11.111 instead of the 192.168.11.123 listed in the manual. I was having the same problem & tried that & it worked.

I will try that. Yes it does.

I will try that too.

Nope no different, perhaps there is a compatibility issue with iOS 6.1.2 on the iPhone, no problems at all with the iPad but I don't really want to have to take the pad to the track

Solara You got mail

So I picked up a Rev. S (Blue Case) and i planned to use it in my Drift car. I thought I would update the software and change it over to the Drift profile.

I see others have posted about not detecting it and I too had the same issue. I tried multiple downloads and uninstalled and re-installed etc. Still not working.
Using an IBM Thinkpad running XP SP3.

Here is what I did-
-Downloaded the latest software from the SP site.
-Once downloaded, ran the USB software- (Windows msg about finding new hardware, tried both cancel and trying to install from the software downloaded)
-Followed the manual instructions
-When I initially connected it, I would see the ESC light up, but later, no lights. I would get 2 dash lines on the LED box.

I did try checking the settings using the box alone, and was able to make changes to the basic settings, but I really need the Software to make other changes. Not sure where to do from here.

I have uninstalled and re-installed a couple times. No Difference.



MOmo

browsing the classifieds and noticed the cirtix R8 up on one.

Curious, what every happened to this ESC? Looked pretty good. No mention on SP's site anymore on it but there is historic info on it.

http://www.speedpassion.net/uploadfi...653R8-w011.jpg

http://www.speedpassion.net/us/produ...3301C8X&c=DIS#