Viper RC -
#961
#962
haha i turned the bec up to 7v on my vtx10 and that savox servo came to life!
haha.. plus it was a fully charged lipo so it was probably in the 7.4 range.
did not have a problem.. i have since turned it down to 5v and added back in the spektrum power cap for the spektrum rx's i like the comfort of the cap letting me know i wont have a brown out or missed lap!
haha.. plus it was a fully charged lipo so it was probably in the 7.4 range.
did not have a problem.. i have since turned it down to 5v and added back in the spektrum power cap for the spektrum rx's i like the comfort of the cap letting me know i wont have a brown out or missed lap!
#963
is anyone running one of these in 4 mod outdoor? any heat issues? im seriously considering picking a few up for my rigs to run outdoor and ditch my other escs, id much rather support someone local than overseas if i can
#964
I ran them in my 4WD FS2 and my SC with hot mods outdoors.... mmmmhmmm fast.
#967
#969
Has anyone tried the new Viper motor with the MMP. I tried it and I'm experiencing a lot of cogging. Change the motor and it goes away. Try a different Viper motor and same thing more cogging. Can't figure out if it's just a software conflict with the MMP
#972
Tech Master
iTrader: (201)
Joined: Jun 2009
Posts: 1,435
From: Red Lion, PA
Those glitch busters seem to take care a lot of glitching issues. They seem to be a must have in the pit box.
Looking forward to the release of these esc's!
Been waiting patiently and have tried pretty much every esc out there. I'm convinced that this is the esc for me even though I haven't used one yet
Carey
Looking forward to the release of these esc's!
Been waiting patiently and have tried pretty much every esc out there. I'm convinced that this is the esc for me even though I haven't used one yet

Carey
#974
Tech Fanatic
iTrader: (4)
Joined: Jun 2009
Posts: 947
From: Burlington, Ont. Canada
I have been a Futaba guy since the mid 80's. When I got back into RC I picked up a 3pks. I have not had a single issue. I knew very little about Spektrum at the time. I ended up getting a DX 3.0 for my little guy. I had nothing but problems with glitching from day one. Re-bound it many times ect.
I ended up ditching my sons DX 3.0 and got him a Futaba 3PL
In the few years I have been back in RC, I have heard about way too many issues with Spektrum radios.
Seems you either get a good one or you don't, and your chances are 50/50
I ended up ditching my sons DX 3.0 and got him a Futaba 3PL
In the few years I have been back in RC, I have heard about way too many issues with Spektrum radios.
Seems you either get a good one or you don't, and your chances are 50/50
#975
I have been a Futaba guy since the mid 80's. When I got back into RC I picked up a 3pks. I have not had a single issue. I knew very little about Spektrum at the time. I ended up getting a DX 3.0 for my little guy. I had nothing but problems with glitching from day one. Re-bound it many times ect.
I ended up ditching my sons DX 3.0 and got him a Futaba 3PL
In the few years I have been back in RC, I have heard about way too many issues with Spektrum radios.
Seems you either get a good one or you don't, and your chances are 50/50
I ended up ditching my sons DX 3.0 and got him a Futaba 3PL
In the few years I have been back in RC, I have heard about way too many issues with Spektrum radios.
Seems you either get a good one or you don't, and your chances are 50/50



4Likes
