the plastic bellcracks flex, worse on the SC10 than on any other B/T4 platform vehicle because of the big heavy and sticky rubber we use. The aluminum bellcranks take the dead feeling out of the steering. It's a very direct feel, but require a metal gear servo.

If the GPM one is in stock, is does the same thing basically. I have 2 of them, one on the T4.1 and the other on the Sc10 . works well.

Can you post a pic of it? And a link where to buy?

HELP!!!!!! A few weeks back i hooked my batt up backwards..trk ran fine for about a week when motor started making a funny noise and quit...i borrowed my buddies same stk motor but it started to glitch out on me...i then bought a reedy 4900kv sl...and it still glitched out when turning and this run it swelled a battery and got pretty hot...so i bought a xp 1200 esc and tried it today with a glitch buster...it still got hot amd completly glitched...it will run fine when free spinning the rear tires...but when u s:confused:et it on bench amd hold it it will glitch out....what do i try next?..ive isolated servo out and still does the same thing....HELP!!!!!

In my opinion, it's not so much the sleeves but that AE chose to run a threaded screw all the way thru them instead of a machined shouldered screw that fits the i.d. of the bushing.

Kind of a shame really - with all the ball bearings in the rack everywhere else, it's like running 99 yards for a touchdown and then turning around on the one yard line to run backwards...;)

12mm conversion
 

is anyone having problems with blowing bearing out on the frontend of the 12mm conversion? please help

which conversion are you using? I have used both and didnt have a problem with either. I switched out the proline kit that came on my used ft to ae parts.
Are you over torquing the wheel nuts? I only have blown out rear bearings with the stock hubs.

Sounds like the case of the Mondays, or you're over-tightening the wheel nuts. Are you using spacers?

how did it break, and how long was the bearing in there? Which conversion did you use?

The front bearings on my sc10rs with 12mm hex front hubs are still butter smooth since X-mas.

This is bull$hit. I had to look 3 pages down to find this page.

anybody?

ok newbie here so bear with me...
I have a Turnigy lipo 7.4 5000 mah 40-50 c battery on a ft i can't slide the battery back very far because the strap won't go in to the slot because the battery is too thick, is this normal? do I need a different battery?

thanks
Bob

Are the TLR 22 and 22T springs the same size? Just wondering what to get if I'm doing the conversion. I have 22 orange/yellow buggy springs on my B4, was looking to do the same conversion for the SC10 but clueless what spring size and color to get. Thanks!!

For the avid aluminum steering Bellcrank install what are they talking about possibly having to shim the bulk head screws to prevent binding? pics would be helpful .... ;)