54LikesRyde it like you stole it: the Ryde Drivers thread.
09-13-2010, 06:40 AM
#7591
09-15-2010, 12:06 AM
#7592
why is it so quiet in the hood, clown and tea lady?????
09-15-2010, 12:41 AM
#7593
09-15-2010, 01:27 AM
#7594
I know I haven't been posting because of my ultra hectic lifestyle over the past few weeks, which Brendan Neal can attest to, he's seen me out and about a few times the last week, really stressing about my work load, too busy even to take phone calls! As Justin and Steve can attest to! As for Steve he is absolutely flat to the floor in Bunnings carparks all over Sydney! Must admit though in a couple of weeks I will start to get busy again, just waiting for some stuff to happen at work.
But Peli has to have the best job of the week - doing an RC polished turd for the ABC! Stay tuned, I'm sure there will be more posts about this soon.
Maybe you could come and work with me now you have some turd experience.
Nick
Must admit though in a couple of weeks I will start to get busy again, just waiting for some stuff to happen at work. But Peli has to have the best job of the week - doing an RC polished turd for the ABC!
Stay tuned, I'm sure there will be more posts about this soon.Maybe you could come and work with me now you have some turd experience.
Nick
09-15-2010, 01:57 AM
#7595
No bunnings carpark sleeps for a while for me, Too many indescretions means that I'm in the "naughty room" (workshop)
It's pretty good, a change is as good as a rest
Good luck to EVERYONE at the states,
I'll be thinking of you while dressed up as a WIGGLE, singing KOOM BY YA by a bonfire drinking heavily, then to retire into a TENT, Not your normal weekend
But the good news is I'm hopefully having a month off work starting next week
It's pretty good, a change is as good as a rest
Good luck to EVERYONE at the states,
I'll be thinking of you while dressed up as a WIGGLE, singing KOOM BY YA by a bonfire drinking heavily, then to retire into a TENT, Not your normal weekend
But the good news is I'm hopefully having a month off work starting next week
09-15-2010, 03:14 AM
#7596
shooo wake up australia
09-15-2010, 03:53 AM
#7597
ok heres a question. my 13.5 turn trinity sensored brushless surges before take off. it will surge a bit then take off.
When i put more timing in using my mamba, it gets worst.
It only does it when the tyres are on the ground, i.e under load.
Brand new sensor cable.
new speedy.
Could this mean the motor has sh*t itself and its time for a new one.
Also. I just tried to run a 27t pinion with a 75t spur... the motor didn't get hot at all after about 5 minutes of bashing.
Is this safe and fine to run. or should i go lower.
thanks.
When i put more timing in using my mamba, it gets worst.
It only does it when the tyres are on the ground, i.e under load.
Brand new sensor cable.
new speedy.
Could this mean the motor has sh*t itself and its time for a new one.
Also. I just tried to run a 27t pinion with a 75t spur... the motor didn't get hot at all after about 5 minutes of bashing.
Is this safe and fine to run. or should i go lower.
thanks.
09-15-2010, 03:58 AM
#7598
FAMILY VS ADDICTION
HOW CAN I RACE ON THE FIRST SATURDAY OF OCTOBER WHEN MY MUM HAS FLOWN 16000KM TO SEE HER SON AND HIS FAMILY (2 GRANDCHILDREN) AND IS ONLY IN AUSTRALIA FOR 7 1/2 DAYS
SERIOUS QUESTION
ANY IDEAS
you can tell I'm serious with the capital letters
SERIOUS QUESTION
ANY IDEAS
you can tell I'm serious with the capital letters
09-15-2010, 04:26 AM
#7599
Tech Regular
09-15-2010, 04:33 AM
#7602
ok heres a question. my 13.5 turn trinity sensored brushless surges before take off. it will surge a bit then take off.
When i put more timing in using my mamba, it gets worst.
It only does it when the tyres are on the ground, i.e under load.
Brand new sensor cable.
new speedy.
Could this mean the motor has sh*t itself and its time for a new one.
Also. I just tried to run a 27t pinion with a 75t spur... the motor didn't get hot at all after about 5 minutes of bashing.
Is this safe and fine to run. or should i go lower.
thanks.
When i put more timing in using my mamba, it gets worst.
It only does it when the tyres are on the ground, i.e under load.
Brand new sensor cable.
new speedy.
Could this mean the motor has sh*t itself and its time for a new one.
Also. I just tried to run a 27t pinion with a 75t spur... the motor didn't get hot at all after about 5 minutes of bashing.
Is this safe and fine to run. or should i go lower.
thanks.
09-15-2010, 04:42 AM
#7604
Tech Initiate
Join Date: Mar 2010
Location: Sydney (somewhere on the Australian coast..)
Posts: 33
09-15-2010, 04:43 AM
#7605
ill try that thanks.