Kyosho V-ONE RRR Evo
#2192
Nice quality..... That gear was under 20minutes of running....
There are some parts wich are not that good....
There are some parts wich are not that good....
#2194
Does anyone know if the kyosh gp-10 spider 4wd is a good enough car to race with?
#2195
#2197
hie all....i got a prob with front tire rubbing againts bottom shock ball joint...i have read previous thread tt some say you should put an O-ring behind the dog bones, but i read thru the manuals it didn't not show that an O-ring is needed, do you guys add an O-ring behind or just unscrew the 9mm pillow ball more ??
#2198
For wheels rubbing the shock balls.
I'm looking at two cars right now with the same thing. Parts on order.
KYOSHO P/N UM112
1. If your txmitter can do it, set the end travel limits or the steering
proportion so the wheels don't touch at full turn. (Move the suspension
full up and down when checking.)
Check the offset on the wheels. .... an unnamed buddy of mine put 30's
on the front a did a good number on his!
Trace
I'm looking at two cars right now with the same thing. Parts on order.
KYOSHO P/N UM112
1. If your txmitter can do it, set the end travel limits or the steering
proportion so the wheels don't touch at full turn. (Move the suspension
full up and down when checking.)
Check the offset on the wheels. .... an unnamed buddy of mine put 30's
on the front a did a good number on his!
Trace
#2199
#2200
Tech Adept
Anyone had ever tried the UFO clutch type from k-factory?
Is it good as they say? Better than 2d or 3d kyosho clutch?
Is it good as they say? Better than 2d or 3d kyosho clutch?
#2201
hie all....i got a prob with front tire rubbing againts bottom shock ball joint...i have read previous thread tt some say you should put an O-ring behind the dog bones, but i read thru the manuals it didn't not show that an O-ring is needed, do you guys add an O-ring behind or just unscrew the 9mm pillow ball more ??
#2203
Tech Champion
iTrader: (91)
Don't like it very much as all of the K-Factory springs are way to soft not to crazy about purchasing an item & you would have to use different manaufactures springs to get it as close to performing up to kyosho's standard Im using the Kyosho 2d clutch more than the 3d
#2204
Tech Adept
Don't like it very much as all of the K-Factory springs are way to soft not to crazy about purchasing an item & you would have to use different manaufactures springs to get it as close to performing up to kyosho's standard Im using the Kyosho 2d clutch more than the 3d
#2205
For wheels rubbing the shock balls.
I'm looking at two cars right now with the same thing. Parts on order.
KYOSHO P/N UM112
1. If your txmitter can do it, set the end travel limits or the steering
proportion so the wheels don't touch at full turn. (Move the suspension
full up and down when checking.)
Check the offset on the wheels. .... an unnamed buddy of mine put 30's
on the front a did a good number on his!
Trace
I'm looking at two cars right now with the same thing. Parts on order.
KYOSHO P/N UM112
1. If your txmitter can do it, set the end travel limits or the steering
proportion so the wheels don't touch at full turn. (Move the suspension
full up and down when checking.)
Check the offset on the wheels. .... an unnamed buddy of mine put 30's
on the front a did a good number on his!
Trace
30's in the front ?????