Watch this video.
http://www.youtube.com/watch?v=Qg9znjIYSRk

I did the same thing. My red light stays solid.

Another TQ and win in 2wd A-main at Hotrod Hobbies in Hamilton, ON.

Viper VTX10 and 17.5

http://www.youtube.com/watch?v=ur9iq...el_video_title

I wanted to give a big thanks to Mark Smyka for helping me this past weekend upgrade the firmware on my ESC and explaining the settings. The throttle feels so much better on the Viper compared to the Tekin I was running.

Is the ESC new? (like within the last 2 weeks)

And do not hesitate to call Viper Tech Support at 1-866-206-8558. I believe they are open 9am - 5pm Pacific

Make sure your radio is properly calibrated

Yes it's new. Definatly under a month

My throttle end point is at 100%. Anything else ?

U know what would be really awesome???? If my new copperhed system arrived this week

Does your radio have ABS? If so is it on? My Futaba 3pl will not calibrate if the ABS is on. also make sure you have the throttle rev/normal switch the right way. That can also cause a problem

bkuff - all good suggestion above to look at... does your servo work?

CCristo - finally, a year later and you have seen the light!!!!

Bobby - congrats!!

FYI - Some race results from the Gobbler this weekend at RCE. Mike Wilder TQ's and wins 2wd Modified with his Viper powered B4.1. Mark Smyka was 3rd with Toddie Anderson 4th. Mike also TQ'd 4wd Mod but had to settle for 3rd behind some pretty fast guys.

eta on the copperhead?

Any time Cristos glad you liked the settings . buy the way your truck looked dialed in the main i am getting one when we get back for fla so get a setuo ready ..


on a side not i ran the same program i posted in open mode last weekend at rce in mass in open mod with a 10.5 and i will say i had plenty of power compared to everyone running 7.5 and 8.5's

Need a 17.5 system for a spec class...can someone point me in the right direction. I notice on the website there are several different models of ESC to choose from. I also would want this to be upgradeable to a mod motor as well.

Thanks

try setting your endpoint values to the maximum. my sanwa tx initially couldnt bind to my vtx10r too until i max-ed the endpoint values.