![]() |
I have a stupid question before I spend the money. When I get the yellow sensor board it automatically adds 30 degrees of timing to the motor?
Blake |
No when you put the yellow board on it has a range from 21 degrees timing to 30! Be very careful you go to much to the 30 degree side and you could burn up the motor! I just put the yellow board in with my 17.5 and have it at about 24 degrees if timing and this thing is fast! Comes off the track at about 145 degrees that's great for a 6 min 17.5 buggy main!
|
Oh and the only stupid question is the question not asked!
|
Thanks! It's going in a 17.5 and I check temps all the time. The help is very appreciated.
|
So I looked on the SP website, twice I will add, and couldn't find the stock0 firmware for blinky to load on my new Revention R. Can someone post a link for this? Please and thank you.
Blake |
if you cant find it by later today, I will look for it on my PC at home and can share it out.
|
I found stock1 but I thought stock0 was the blinky firmware?
|
Originally Posted by zeakemedia
(Post 12683112)
So I looked on the SP website, twice I will add, and couldn't find the stock0 firmware for blinky to load on my new Revention R. Can someone post a link for this? Please and thank you.
Blake
Originally Posted by zeakemedia
(Post 12683247)
I found stock1 but I thought stock0 was the blinky firmware?
http://www.speedpassion.net/files/SP...v1_1_0_23b.zip It will install the necessary application on your computer. When your ESC is connected and you select change Firmware, one of the options will be Stock0. |
Originally Posted by MOmo
(Post 12675116)
So for clarification......
Can you make adjustments to the Rev Club stock via the computer (not changing the software, but rather fine tuning Blinky) or are you limited to only using the LED prog. Box? Momo |
Originally Posted by zeakemedia
(Post 12677357)
I have a stupid question before I spend the money. When I get the yellow sensor board it automatically adds 30 degrees of timing to the motor?
Blake |
Originally Posted by zeakemedia
(Post 12683247)
I found stock1 but I thought stock0 was the blinky firmware?
|
Thank you very much. I will be getting the green board then. No need in burning the motor up. Gonna give this blinky thing a try for once.
Blake |
Originally Posted by Solara
(Post 12683331)
No...it cannot, the computer would not recognize the ESC. You can only adjust the parameter with the LED or LCD card.
I was beginning to feel a little crazy. Momo |
will be doing my installs this weekend of the stock club race systems, albiet on some VTA usage vehicles. will report how it goes.
|
Originally Posted by Cain
(Post 12685951)
will be doing my installs this weekend of the stock club race systems, albiet on some VTA usage vehicles. will report how it goes.
I have raced with a Short Course, VTA and USGT car with Stock Club Race ESCs. If I remember right a previous USVTA Scale Nationals winner ran the Cirtix Stock Club Race in his XXXS G+ and won that race. The Reventon Stock Club Race works just as well. |
| All times are GMT -7. It is currently 06:30 AM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.