Been running a LRP X11 7.5 in my SC10 with a GT2.0 LPF esc with 428MOD (no changes to programing).

With the LRP starting to show its age, I ordered a Com V3.0 7.5 today to replace it.

Is this still THE program (428MOD) to run or is there a better one?

I race at these tracks.

Red Clay
http://www.t3t4webservice.com/fzrc.html

Carpet
http://www.t3t4webservice.com/HMIRR.html

Presume this is 2wd not 4wd? How are you gearing it? I want to put the LPF in my SC, though I might switch and try a different HW 120a.


MOmo

my brand new 2.1 pro stock esc went out after the 1st 5min run...Never got hot,ran perfect...all lights come on and fan..does not make beep sounds when I try to recalibrate but it does show the light blinking...Running a sp 10.5...Also tried another motor with no luck:cry:...Never had an issue with speed passion,especially a brand new esc....

How do I put a Reventon S into blinky (stock0?) mode? I was using the LED programmer last night and I couldn't find a way to get it out of Mod0 mode.

Also, I have a 17.5 v3.0 that just stopped working. It was running fine for 5 min or so with good speed, then it would only move at nearly full throttle, then it stopped all together. I checked voltage and it was 8.0v (2S) and motor temperature wasn't even warm. I turned the ESC on/off with no change, tried a rolling start and no change. I swapped out the motor for a Turnigy 17.5 and ran for the rest of the night, even down to the 3.4v/cell cutoff without issue.

to change the firmware you need to hook it up to the computer. The box is for changing the settings with whatever firmware you load into it.

Totally dumb, but did you switch Sensor wire? Same sensor worked on the Turnigy?


MOmo

I am new to speed passion products but have heard a lot of good things about them, here is what i am looking for, I just purchased a B4.2 and am looking for a ESC and motor for it but really don't know which products speed passion has to offer that would be right for this buggy? Any info would be great.

SC10 not a SC10 4wd

Had to look! Haven't changed the gearing for over six months.

20/84

Was having a heat problem, a race buddy shared Maifield's setup from the ROAR race at Norcal 2011. The radio setting made the difference.

i use speed passion reventon pro with 10.5 competition v3 motor on my trf416x...anybody what is the best esc and gear setup...

yep, same sensor wire on both motors. Everything exactly the same except for the motor.

Mod or Stock?

im selling my reventon pro if anyone looking. ive got a post up in the fs section

can someone explain how this hobbywing sct pro can be such a great 4wd sc or 8th scale esc with less amperage ratings than the reventon pro?

http://builtrc.com/hobbywing_xerun_esc_sct_black.aspx

Output: Continuous 120A, burst 760A;

http://www.amainhobbies.com/product_...sored-ESC-Blue

Current (Continuous/Burst): 140A/960A

Ended up ordering a rev pro this morning. Which profile is preloaded?

Pretty sure mod 1 will be loaded.