R/C Tech Forums - Viper RC -

You will be fine down to a 6.5 . 4wd mod and TTC will be a little tough on if due to the amperage being pulled but just stay above a 6.5 abd you will be golden

1fastdude

07-26-2011 03:36 AM

Quote:

Originally Posted by SC_RAGE (Post 9425370)

For a 7.5 leave the timing alone and runt it in stock mode no boost timing. Set the throttle PWM freq 4000-8000. punch at 80%. Gear it till you get proper temps. 140-160 degrees. It shoud be good.

Thank you

What is "PWM" ? :confused:

Dlewis4

07-26-2011 03:48 AM

Quote:

Originally Posted by culture6 (Post 9439405)

Not even with a 7.5 turned down to 60 percent?

See post above.

Dlewis4

07-26-2011 03:51 AM

Quote:

Originally Posted by 1fastdude (Post 9440140)

Thank you

the
What is "PWM" ? :confused:

I believe it means Power Modulation. Basically throttle frequency. It affects how smooth
The throttle steps are.

OWTKAST cpt

07-26-2011 05:42 AM

Can we get some ESC sheets please?

I won 2wd buggy Saturday but those pesky tekins still pull me on the straight. I tried to take what I knew from the tekin and use it with the progauge but I still cant quite get it right. Don't get me wrong I am keeping the viper in my car, I think the profile 4 was great, but can we PLEASE get some setups somewhere.

Thank you

Chase

Dlewis4

07-26-2011 06:01 AM

Quote:

Originally Posted by OWTKAST cpt (Post 9440446)

Motor? Car?

culture6

07-26-2011 06:42 AM

thanks guys, It's probably going to be turned down even more, it's going in a 22 so I can't imagine it harming it..

Dlewis4

07-26-2011 06:47 AM

Quote:

Originally Posted by culture6 (Post 9440649)

thanks guys, It's probably going to be turned down even more, it's going in a 22 so I can't imagine it harming it..

You will be fine. I ran with an 8.5 at full bore on my VTX10 and it ran just fine... was able to use it all too

SC_RAGE

07-26-2011 08:52 AM

Quote:

Originally Posted by culture6 (Post 9439405)

Not even with a 7.5 turned down to 60 percent?

Im sure it will be fine in a buggy. I for some reason was thinking it was another vehicle. lol Yea you should be ok. Just dont overgear it. The 10 has a single board, And the 10r has two which dissapates more heat. The 10 is more prone to heat under higher loading. It should be fine with the buggy though.

culture6

07-26-2011 08:55 AM

i'm new to the viper bandwagon, and I got tired of my tekins' so time to use something different(:

Dlewis4

07-26-2011 09:32 AM

Quote:

Originally Posted by culture6 (Post 9441143)

i'm new to the viper bandwagon, and I got tired of my tekins' so time to use something different(:

:):nod::)

OWTKAST cpt

07-26-2011 09:44 AM

17.5 Losi 22

Asked before bit never got replies. Its just nice to see a few sheets with track conditions etc listed for quick reference. I also need to just learn more =)

Dlewis4

07-26-2011 09:51 AM

Quote:

Originally Posted by OWTKAST cpt (Post 9441371)

17.5 Losi 22

Asked before bit never got replies. Its just nice to see a few sheets with track conditions etc listed for quick reference. I also need to just learn more =)

Will see what I can find for you. I used to run 17.5 stock so i will have to hunt down my book of setups....

SC_RAGE

07-26-2011 03:21 PM

Quote:

Originally Posted by Dlewis4 (Post 9441395)

Will see what I can find for you. I used to run 17.5 stock so i will have to hunt down my book of setups....

I posed andrew smolniks setup a few pages back for 17.5 if you need i will pm them to you later.

All times are GMT -7. It is currently 09:31 AM.

Page 157 of 805

« First

107

147