S_fender

You have 100% on left and right turning on the radio but on the tracks ? The car turn in the same way on left and right ?
Personnally i'have 80% left and 100% right on the radio.

scottw

iTrader: (1)

that too is why I sold mine for the new xray t2. The TC4 would push no matter what I did to it. I got tired of fooling with it after I won the series with it. Just too damn much work just to try to go through corners. Best of luck with her.

scott

lotus1

iTrader: (21)

Rubber or Foam? Carpet or Asphalt?

AM03GT

iTrader: (13)

i don't think you're going to get much help here on an SRD, from what ive seen of it on a web picture or two, its got wider hinge pin locations, shorter suspension arms, short upper links... most likely the weight distribution is slightly different too due to mounting locations and such... with this much of a difference in the cars the setups will not translate over exactly...

AM03GT

iTrader: (13)

roadrashracing2

ok thanks!

bukil

iTrader: (39)

Rubber on asphalt.

Thanks,
Mark

bukil

iTrader: (39)

Rubber on asphalt. Anyone know how to fix this (refer to my previous posts)?

Thanks,
Mark

Bob Barry

iTrader: (22)

Front
70 wt losi oil
2 piston
purple springs
inside on arm
2nd hole out on tower (laid down)
camber - 2nd hole out silver ball stud no washers
4 deg castor
5mm ride height
droop - 2mm over ride height
steering rack - silver ball studs no washers
2 shims in front of arms
no shims under blocks
thickest sway bar
Double Pink/Orange

Rear
60 wt losi oil
2 piston
copper spring
outside on arm
2nd hole out on tower (laid down)
camber - 2nd hole out silver ball stud no washers
Losi XXXS Zero deg hubs inside on hub no washers
no washers under blocks
5 mm ride height
droop - 2 mm over ride height
double pink

no sway bar (this made a huge difference)
BMI Chassis/top deck/ motor mount
Team Express C2 (19T) geared 35-104
Team Express IB3800's
Parma Alfa

bummy

MY NEW BODY NOT BEST, but good considering it my first attempt at more then one colour dont mind the bleeding but, i used masking tape

AM03GT

iTrader: (13)

bukil: is your "wide turn" a low speed issue or a high speed issue? as for your setup i would first try a major step in either direction to get an initial feel for the direction you need to tune to. i.e. put a gold spring in the rear to stiffen the front and see what it does... then put a green in the rear and see what that does... these are pretty extreme changes and may make the car pretty crappy around the track, but wht you're trying to get out of it is a feel for the change in track feel when stiffening the front, and when making the rear softer. from this you should have a rough idea which direction will solve your issue and make smaller steps in that direction from your original setup...

bukil

iTrader: (39)

I have tried that setup before. Gold springs in the front and silver in the back. It was crappy. I had a very nasty oversteer. I also tried silver in the front and green in the back. It was better. So far, the best setup that worked on my track is the one that I posted here.

I get wide turn on low and high speed issue but mostly on high speed. Anymore ideas?

Thanks,
Mark

bukil

iTrader: (39)

I take that back. I get wide turn on low speed. Our track here has a lot of twisties.

Thanks,
Mark

bummy

i got a problem with me tc4, when i go around a corner, it seems to flick the back around? any suggestions? l

bummy

also i just purchased 2 sway bar sets for my tc4, do they make a difference?