The MS just came out so I wouldn't cound on a new car any time soon.

BTW, the EvoIII and EvoIV oneways are the same except the gear sets are different.

it'd be cool if they did MS bulkheads not only in green.. but in other colors too

OMG Thats HOT!!!

what about for the 415MS?

Anyone know where i can find a blank EVO IV MS setup sheet that i can download ?

I will e-mail the setup sheet to you - pm me your email address

Yep thats Cool... also the flight back to Japan was good... just too long
-Dave

What are the differences,is any, between the Evo III suspension blocks and the blocks for the Evo IV?

no difference

Same... but the EVO4MS blocks are the same as the 415 bolcks

Pls, for me too :-) read PM

Got a question for you fellow Tamiya owners...I am trying to race my EVO IV on carpet but I can't get neither the 26 or 28mm foam wheels to fit! If anyone knows what part I need to somehow offset the wheels so they can fit without the front wheels rubbing the steering blocks? Thanks.

You can run Pro4 front spindles in place of the Tamiya ones. However, you'll need a few things to do so. I just don't remember what it was hehe. Also, if you run Parma tires, they are offset differently than Jaco. You might beable to get away with using them and the 6mm silver wheel hexes. Maybe even X blocks too to narrow the car width. I can't remember...

http://www.speedtechrc.com/store/ebp...nid=276&id=823

If I get these 6mm hexes, will 26mm Powerline foam wheels clear this?

where can I get the TRF Green Shock Parts?

Over here in Japan they sell just the Green damper ends with a floro coated shock case in pairs.. I don know the part # off hand but I can find out later today

-Dave