|
Originally Posted by micrors4guy
(Post 6138658)
I believe they said there will be a sc10 version also.
|
Originally Posted by Raul Garcia
(Post 6138422)
Orion Vortex 1007. Sick, sick, and sick.:nod:
|
Bummer that some of the aftermarket truck bodies are starting to look like Euro roundy fendered beaters instead of trucks.
|
Where do you guys get your suspension arms and the nerf bar things from? I just sorta had a mid air collision with a pole:(.
|
4 Attachment(s)
Originally Posted by 1999zr2
(Post 6137320)
Does anyone have any pictures of the J Concepts Truth body mounted up? Any pros or cons to this body compared to stock. Curious what it looks like as I have the Ivan Stewart Red/Orange/Yellow Toyota racing scheme ready to go on something.
I also have a couple of Factory Team blue front hinge pin braces I am not using. Part number 9665. One opened one not. $11 shipped in the usa. email [email protected] -Eric Attachment 482775 Attachment 482776 Attachment 482777 |
Originally Posted by Krio
(Post 6138627)
Anybody notice the inner shell JC made for the slash? First company to make one for the sc10 with a driver figure available to bolt in wins!
|
I just bought an SC10 used from someone with stripped out wheels of course so beadlocks here we come I guess :nod: I am piecing it together rite now and needed some gearing recomendations. It will have a Novak SS5800 set up which I think is similar to a 17.5? Any recomendations? Thanks
|
Anyone interested in an SC10 roller? It's CLEAN, seen 1 race weekend and 20 minutes on the street. PM me.
|
Originally Posted by F N CUDA
(Post 6139156)
Bummer that some of the aftermarket truck bodies are starting to look like Euro roundy fendered beaters instead of trucks.
|
what gearing should i run with a mamba max and 5700kv motor?
running indoor, clay, larger than most indoor facilities. |
Originally Posted by Pimpin
(Post 6141768)
what gearing should i run with a mamba max and 5700kv motor?
running indoor, clay, larger than most indoor facilities. * |
Proline Split Six rear wheels for SC10
I just got a set and i noticed that proline designed the wheels exactly like the stock SC10 rear wheels leaving the axle mounting area hollow. The plastic seems sturdier but i'm just wondering if they will strip out just like the stock wheels if the wheel nut backs out. maybe i should do the BJ Weld mod on theses too.
Your thoughts ? |
Originally Posted by vysoto
(Post 6142178)
I just got a set and i noticed that proline designed the wheels exactly like the stock SC10 rear wheels leaving the axle mounting area hollow. The plastic seems sturdier but i'm just wondering if they will strip out just like the stock wheels if the wheel nut backs out. maybe i should do the BJ Weld mod on theses too.
Your thoughts ? |
Originally Posted by tedstryker
(Post 6142547)
you should have just done the 12mm hex on the rear..and used the slash beadlocks that pin to wheel hub is an awful design.. i did my sc10 12mm hex front and rear...
|
Originally Posted by micrors4guy
(Post 6142641)
i have yet to strip out a wheel on any of my cars that have pins for the wheel area. B4, sc10, b44.
|
| All times are GMT -7. It is currently 09:08 AM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.