ffpm46

iTrader: (179)

Anyone...

I have my tekin 1900 system, When I program it, the sensor wire won't allow it to go. When it is unplugged it spins. I calibrated like the instructions say. Any suggestions?

ffpm46

iTrader: (179)

The system works without the sensor wire, also the fan doesn't spin.

QUICKGUESSWHO

tekin is going to give me a good deal just for the RX8. im puting a Novak 4400Kv motor with it.(all ready bought 2 11.1v packs).

20 SMOKE

iTrader: (103)

do you have access to another sensor wire you might have a bad wire

R-E-A-P-E-R-

iTrader: (13)

What is a hottest safe operating temps for the esc and motors???

Stealth_RT

iTrader: (5)

Make sure you have the motor wires connected in the proper order, A-A, B-B, and C-C.

chevydc44

iTrader: (35)

I was just wondering if tekin has fixed there motors for 1/8 scale i know some people that have blew out the shaft coming unglued i run the mmm system and it works great but i would like to try the tekin motors but i don't want to buy it if that is gonna happen

UltegraSTI

iTrader: (20)

while my new 8 wont see 1 of these any time soon like its 1/10 brothers here on the workbench. i will say i had the privilege in watching some of these units being born out at the factory yesterday and take heart folks that they are really behind this movement and feel its the next 'real big deal'. they are in fact preparing for a 6hr race out west against all nitro rides. hope there's some vid!!

R

20 SMOKE

iTrader: (103)

5-6 led's if 7 shows up gear down,no more than 190 on the motor

R-E-A-P-E-R-

iTrader: (13)

Cool mine isnt anywhere near that. But I did have some problems today, Who is the best person to contact for problems???

X God

iTrader: (3)

I took Jube's advice and geared up to 46/18 and WOW did it come alive. Ran it in practice hard with full EPA and ran for 18+ minutes and I know I could have made 20. Motor was at at cool 160 degrees

20 SMOKE

iTrader: (103)

what's your led's if its 4-5 then leave it,but what is the problem

R-E-A-P-E-R-

iTrader: (13)

It isn't doing anything now. It appears to have just died. No LEDs no sound. My servo is still working but that's it...

XXXDad

iTrader: (198)

Call Tekin on Monday... If your ESC went bad take it out and box it up and send it express to them It will be back to you in a few days! Tekin is #1 when it comes to service!

Jube

iTrader: (43)

Glad she woke up for ya Lou!