Similar yes , same no

These sweep tires rock!!!!


Also this competition heater is frickin sweeeeeeet!!

Looking forward to getting one of those, money order should be there mon or tues

Montey, do you have a piston,sleeve and rod for a plus 4. I need to do a rebuild on mine. I don't care if its the p/s rod combo or seperate.
Thanks
Kevin

Monty, is it normal for a N21R with about a gallon on it to only get around 6 minutes of runtime?

No way jose !! I have seen average of 9 1/2 min with 8mm , odo100 and dynamiyte 086

I would say your tune is wayyyyy off cory , try leaning low and richening high .

HEY Monty!

just looking around and saw your name...thinking of getting into it again where is a good place to go nowadays? if you don't recognize my name my dad used to own home town.

hey monte you have a pm

I'll have to give that a try next race.

No pm jerry


Of course I remember you adam , I take it the military is done with ya

Email me @ [email protected]

Will there be a big runtime diffrence between the 3005 and 9901 since their not the same? Thanks

I did some calculating based on how much fuel was left in the tank after the last 5 minutes of the main, and there was 50cc left. So i could have gone around 8 minutes. The 6 minute runtime was based on the tune i had during practice.

Let me put it this way , I have a 3005 pipe in my pit box , that's where it stays

9901ss has good power and great mileage , if u have them both , try em out back to back and learn how they perform different in your own way . No better way to learn than hands on

How about the 9901 vs 2084 pipe?

Just wanted to let all the HES customers know Competition Heat is proud to have Monty as one of our Dealers. The Comp. heaters should arrive today Monty.

only way to heat ur engine is the comp. heat way