I wonder what the above would be like with one of the timing advance esc's.. 4 speed? Maybe the 2 gear can hit when the timing advance is up and make it ballistic?

I don't think it will be a huge difference. Two speeds work better on larger tracks but I bet it you where trying for top speed only then a two speedo with these new boosted speedos you could get some huge speed.

E4 is now sold. Thanks for all who PM'ed me as I had alot of guyscontact me about this car. I appreciate everyone taking time to look.

Going to miss runningthis car and posting on this thread. Been a pleasure.

Brian

Nice : http://www.teammagic.com.tw/en/newsf...21135202-42761

Mhhh anyone alive guys ?, what happened ?

cya,

Pato Concha
Southamerica

Wel as Wyd did sell his car and for me the outdoor season is over that will stop some posts.
I am waiting till the indoor season start and i get the change to feel what it is going to do there.
So for this moment no news for me besides that i have a second E4FS and a E4RS for spares.
Now waiting to get my Tekin RS Pro and start to understand that one.

cheers Roy

Seeing as we have some spare time to chat, is the K Factory heat sink going to work alot better that the 3Racing one. Is the motor heatsink necesary.

Dunno about the 3Racing heatsink as i use the K-factory kit without the fan.
Yes you do need the heatsink.
If you don't you will fry the motor when running with high temps outside or inside.
It also depends on what motor and FDR you are running tho.

cheers Roy

does the K-factory heatsink fit in the E4RS 08?

Sure it will




See??

cheers Roy

I don't know if you need a heatsink all the time but it never hurts if you have one that fits. I didn't get to run my E4 outside but I was going to make a fan setup for it but never got around to in since I was running indoors. I like either setup with a heatsink or fan or even both.

Do they withstand the run-ins with Hara much better?

I just noticed Wolf has an upgrade kit to help take out any play in the suspension and make the car a little tougher.

http://www.wolfhobbies.com/Wolf_Hobb..._and_E4RS.html

Compared to stock it takes out alot of the slop plus the parts look great to.

Only thing I had to do was to lightly sand the caster blocks where the bearings go into them. They fit just a little tight with the anodizing so I just sanded a little and the bearings fit in great. No binding at all. WOlf has some nice alum parts.

which shocks and springs are you using?