Stick the screw back in there and thread it in about 1/2 way, then tap the allen head with a small ball peen hammer, once one side comes completely out then you will be able to twist and pull out the carburetor.

Esteban,
Did you oil your engine pretty good? saturated with after run oil?

I use about 10 drops of it, then just spuned it on the box a couple of times. Should be good. Bring me some of that tornado oil.

sure enough....thanks for the help guys!!

Is it possible to use a Mega ZX-12 conrod in this engine? These are best available in the Netherlands.

rgds,

Jeroen

Yep, just make sure you get the newest generation T3: #202182

Hey guys, Any videos of the Red Dot in action? Cant find one.

Cheers.

Hi JL fans,

I can't seem to find a JLR 3 here in Hong Kong so I'm going to buy it's cousin, the P1-R Evo3. Before going out to purchase the latter, I just want some assurance the the two are exactly the same in specs and performance. I have a 2607 pipe that I currently use on my Mega ZX12 and intend to use it on the P1-R Evo3. I assume that it's still the best pipe for it.

I know this has been asked before but how would you compare P1-R Evo3 to the ZX12 in terms of performance. Just want to make sure I'm doing the right thing.

Thanks in advance for your replies.

The JLR 3 and the PICCO P1-R EVO 3 engines are of totally different specs, the JL EVO 3 is faster, had a different crank and have modified backplate.

Isn't RC Mushroom in HK?

http://rc-mushroom.com/product_info....ducts_id=13636

Q:
Is the skyline pipe made for picco based or nova based engines?

Skyline pipe is a universal pipe/all around pipe.

Ok, but if i were to get one what exhaust gasket would i use with my Picco JLR?

You use the PICCO exhaust seal for Nova Rossi based manifold, this is the extra seal that came with the JL engines, this is the part #51997, you can look it up thru my website.

will the lrp glow plugs work with the red dot, from what i was told the
lrp motor are picco base motors and plugs