i have 100 plus screws left over !

I forgot to put the rear diff in

that is a very serious problem !!!!!!

Trying to reduce weight.

i mean your MTX3 will be much lighter then mind !!

I got 2 thick and 4 thin shims in my kit for the rear camberlink...

I used the 2 spare shims for the arms.... I had to sand them a little to get a perfect fit. Then I wanted to experiment with the camberlink.... lucky for me my LHS had split a kit for parts, I got the packet of shims from it for 5 bucks.... It also had 2 thick and 4 thin.

I got some .010" (0.25mm) 1/8" diameter shims (electric motor shims) and put some on the rear A-arms to remove the uneven movement. Needed 2 on each side only.

One thing that puzzles me: My car have the front axle underdriven - rolls less than the rear axle - is that true (basically it's a rear wheel drive)? Just ever seemed that the front end should be slightly overdriven.

I messed up the assembly swapping some pulleys? How is your car?

Today is the day for their virgin run (if none says me that I messed up with the pulleys).

where can i get alloy servo horns.... or what brands have these items? (they seem like a good idea? so much stronger...)

In oz, model engines and dawn trading distribute them.

Are a good idea if you have metal gears on your servo, if not, go with the plastic servo horns that make Serpent (part no. 1612 for Futaba type spline).

Scrounge through the box till you get all the bits of paper out and read them before building.

I missed the itty bitty one that had the rear arm correction.... Lucky I went to set my droop before its debut run, would have looked like a tool fixing it at the track.

the alloy arms are in stock at frontline hobbies in newcastle around $10 aus or through microshop in the states the ones at frontline are eagle brand i believe
http://www.frontlinehobbies.com

Yah, I did the same thing too.

I don't bother screwing in the upstop screws, I never use them

If you guys had the choice between these two engines, what would you go for?

Novarossi RS-12 S3
or
Siro S12 TRP

I dont use upstops either... but still put them on for some reason...