+1 on 95% of tracks you wont get any extra performance as the ae shocks are really good.

once (if) avid comes out with their springs for the sc104x4 you wont get any better combo for this truck than ft shocks + rcshox piston + trackstar x-rings + avid springs ... heh

The AE 4x4 shocks bigger than the scte ten 4x4? My springs are rubbing on the shock body. I wonder if BB / oversized springs are needed more often as a stock part.

Give it a couple of months

yeah i know im waiting lol. even when i ordered some bearings from them a few weeks ago that was part of my comments...

sc104x4 springs, as individuals, and b4/sc10/t4 springs individuals lol.

What ball stud washers are you guys using? I tried the associated ones that I normally used and figured out they are not 1mm the are .030. Are there 1mm? http://www.amainhobbies.com/product_...stud-Washer-10

I have a set of TLR alloy washers from my 22/22T days.

I use washers from 3 Racing. They come in a few different thicknesses

The 3 racing ones look pretty trick.

http://www.amainhobbies.com/product_...lstud-Washer-8

so fresh and so clean, 4x 2mm 4x 1mm spacers

#4617 bulkhead shim

4x 2mm 4x 1mm 4x .5mm? i still dont like that i cant use my button head screws in the "open" holes on the ballstud tho hah.

Don't think so , like cus yeah have to use those shinny ball studs washer's & stud can get bent like a banana....

just saying

replaced last week end with the big washer's and its way stiffer & stronger now...

idk i have had a few crashes and my banana is still hard and straight... of course i am using ti-nit ballstuds

What is the point of the button head screws?

When doing the 8mm mod, do you install the C hubs up side down? What ball stud do you need? Also, where are guys putting the 2.25 oz. up front?

Thanks!