Your on mind now ...

If anyone has a warped arm ?
show me a picture or something cus i still have never seen one yet

He's on your mind? Hmm what you thinking about him for WC lol jk jk...........

Ehh back on topic, hopefully I can get to the track and run both my sc10's to compare the saddle pack vs. center stick pack............. Just got to wait for new esc to come in, which will hopefully be within the next week or two..........

Whats the new esc?

Here you are:

http://www.rctech.net/forum/9763534-post8351.html



That one isn't that bad. They bend right at the sway bar screw, from there diagonal through where the gap in the inner a arm hinge pin.

ilan , sorry for the miss sp ..

Yeah know ilan?


I only try to help others members
of this board with the Ae Sc104x4 rides .


My main goal and objective here is also to make it a fun & a friendly experience for anyone who joins us .....

Have you used the new multi part slipper? Do you think it will be better than the Garodisks and Mtk slipper?

Thanks for help

Do you happen to have a setup sheet i can peak at? hahaha

Thanks
I think I will try the rpm's, there only like 20 bucks for all 4 corners.

It essentially IS the MTK slipper, only it fits under the gear cover a little better, and looks a touch lighter. Same basic principle.

Personally, I'm really digging the dual garodiscs right now.....only had a chance to run them at one track (local isn't open yet...we're still getting snow as of yesterday...had to drive 5 hours south!) but for a slipper, I feel it keeps wheelspin in check while still having the punch to clear the same jumps that the 3diff trucks can.

iam looking for a new place to live . iam gooing to be mia fro a few

Not yet, I'm going to order one for my 2w. I'm leaving the MTK slipper basket on my 4w.

No, but it won't be worse and it's $15.

Absolutely!

I do for Dustin's track, but I haven't ran at the indoor track yet. If it rains tomorrow AM I'm planning on practicing all day (can't plant if it rains).

I'm going to use Cameron's base setup to start. This is an older setup, but it's pretty close.



They bend too, only quicker IMO because they are stiffer.

A couple more questions about the handling/design of this car.
So the weight is biased to the rear. This affects handling on ruff tracks, but how?
Say I got a SCTE what differences would I notice besides flight?
How much weight needs to be added to the front to balance it out?

Its a toro esc, the original one I got had some issue's called ckhobbies and spoke to Mike (believe thats who it was) and he said he'd send a new one asap (they are out of stock right now, should be in by end of week)...... The stick pack sc10 is my backup rc and going to mainly be used at my indoor track the FT one has my rx8/pro4 setup and will be mainly used at my outdoor track.....


To WC, its all good not everyone can get along but thats just life..........

Running the front springs in the rear cures the jumping problems.

It doesn't need weight up front.

comparing to a Losi is comparing apples to oranges.

They run in the same class though.

lol so..