Thats what I want to hear! This is just a mess around and have fun buggy that needs to be silly fast.

Thanks

Don't have a heart attack...LOL
Happy New Year.

they are quite fast even with 2 pole motors in it, 5.5 - 8.5 seems to be what most people run. i'd definitely be cautious with that torquey 4 pole motor, especially with the plastic diff and pinion gears this car has. make sure you adjust the slipper on the loose side

Yeah let us know how it turns out.

Try green up front it's dialed on a medium size medium bite clay track!!

Good to hear. I have green fronts as well. I will have to try them. Can not wait to try the car with the springs though. Going to start with 35wt front oil and 30wt rear as well.

I don't know he may be ok. The b44 drive train is pretty much a tc3 drive train and on YouTube they have some tc3 on 3s
lipos doing 120 mph. But the 4 pole motor will have crazy torque in this little buggy. It sounds like a fun back yard basher for sure. Post a video on YouTube with the 4 pole I'm sure it would be funny to watch....!

The build went very well. I can't wait to get it on the track!!! Not sure why I waited so long to retire my B44

HAPPY NEW YEAR!!!

Looks good. The body looks stellar!

My Viper system quit working in my B44 today so I put in a Castle Sidewinder ESC and a Castle 3800KV 4 pole to see how it would do. I like it better than the Viper 10R with Viper 6.5 motor. This thing is crazy quick now. There are to triple jumps on my backyard track that I couldn't clear with the Viper gear because of short run ups but I'm getting them now with the Castle combo. I think I'm going to get the Viper stuff fixed and sell it and keep the Castle combo in my B44. I think it's either the sensor wire or sensor board thats bad because the ESC wont sink with the motor now? Oh yeah the Castle stuff is staying a lot cooler also. The Viper ESC and motor would get pretty warm even in 50 degree temps.

does anyone have a problem with the bottom side of the rear transmission casing breaking?i noticed mine was cracked on both sides of the bottom rear screws. so i replaced them last night and after one heat tonight it was broke on both sides again... will it help if i boil the casing? does anyone have any tips on what i can do to stop this from happening every race.. thank you

I have had it happen a couple times but it was due to thrashing it. Don't over tighten them and be sure your top deck is tight. No sure fix that I know of?

thank you! I will double check the screws and the top deck. I race on a very tight technical track.. it is very hard to hit the backsides of each jump. A lot of air.. but have to use very little throttle if u want to hit them right... Everyone does a lot of flat landing.

got a new body and saddle packs for Christmas. Just picked up some smc 5200 60c's for 65 shipped. They're exactly like the losi xcelorin. great packs so far

Running a viper 6.5 with stock spur what size pinion should I be running on a small to medium size track? I dont have a temp gun but my motor and esc seem to be getting a little to hot.