R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: Bad Inferno
Showing results 1 to 23 of 23
Search took 0.01 seconds.
Forum: Australian Racing
06-26-2008, 06:21 AM
Replies: 2
Views: 688
Posted By Bad Inferno

Any tips for the Kyosho SIII kyosho cup addition

Guy's

Just building the siii Evo kysho cup addition. Any tips on setup or biulding this car. I don't race however am close to SERCCC in dandenong Vic.

rob
Forum: Nitro On-Road
07-11-2005, 05:13 AM
Replies: 102
Views: 36,036
Posted By Bad Inferno

spares

no luck with the handle. have had no time at the moment.

Where do people buy parts for the SIII. Has anybody found an online store with siii parts. I need a chassis ! this dame car is soooo...
Forum: Nitro On-Road
06-29-2005, 05:42 PM
Replies: 102
Views: 36,036
Posted By Bad Inferno

handle

How can kyosho build such a great car without a handle !......I have the 3 racing handle for my SII I will see this weekend if I can fit it. Think I woiuld only have to reshape the wire handle the...
Forum: Nitro On-Road
06-25-2005, 04:20 AM
Replies: 102
Views: 36,036
Posted By Bad Inferno

GXR15

I have been looking at my idle problem and have:

1. Found the nut on the engine block which holds the carb in place was a little loose. Although I could slightly rotate the carbie I do not know...
Forum: Nitro On-Road
06-25-2005, 01:41 AM
Replies: 102
Views: 36,036
Posted By Bad Inferno

GXR15

Hi Kyosho Racer....
I've struggled today with tuning this engine. It has MORE than enough power however does not come back to idle very well today.

When comming back from reving the engine still...
Forum: Nitro On-Road
06-23-2005, 04:04 AM
Replies: 102
Views: 36,036
Posted By Bad Inferno

Fifth body post

Kyosho Racer,

You talked about a fifth body post......I noticed on my previous 200mm bodies they start to crack across the top of the front wheel arches. Does the fifth post stop this ? I might...
Forum: Nitro On-Road
06-21-2005, 08:00 PM
Replies: 102
Views: 36,036
Posted By Bad Inferno

SERVO SAVER

Don't know if you had this problem however when I did up the top screw that holds the servo saver shaft in place it was binding under that top plate. I ended up using some locktight on it and not...
Forum: Nitro On-Road
06-20-2005, 05:21 AM
Replies: 102
Views: 36,036
Posted By Bad Inferno

SIII steering

Ben,
Thanks for the reply...I have yet to race, got two boys and am trying to get my 8 YO into this hobby, at least he can get around the track without crashing. I will be very sad when serccc has...
Forum: Nitro On-Road
06-20-2005, 03:44 AM
Replies: 102
Views: 36,036
Posted By Bad Inferno

Red face Hello Kyosho Racer....I live close to SERCCC and...

Hello Kyosho Racer....I live close to SERCCC and only get 1 hr a week for a run around the track.

What are your thoughts one the following:

Exhaust Manifold & Pipe:
I fitted my Nova Rossi...
Forum: Nitro On-Road
06-17-2005, 07:32 PM
Replies: 102
Views: 36,036
Posted By Bad Inferno

Chaya....Chassis 3 or 4 mm

Hi Chaya,

The stock chassis is 3mm however the side edges have been folded up 30 degrees. This would give it great strength.
Forum: Nitro On-Road
06-17-2005, 05:47 PM
Replies: 102
Views: 36,036
Posted By Bad Inferno

Hot Head !

How did you run the engine in ?....I ended up idling 2 tanks, idling with slightly different speeds another 2 tanks, then I have probably only done another 3 tanks smoothly around the track.

The...
Forum: Nitro On-Road
06-17-2005, 06:17 AM
Replies: 102
Views: 36,036
Posted By Bad Inferno

Running in

I just run my SIII in using 16% nitro.....My head did not turn purple and I found I now run my needle 1.5 turns out. Still heaps of smoke comes from the exhaust. I am changing to 20% coolpower fuel...
Forum: Nitro On-Road
06-14-2005, 05:23 AM
Replies: 4,584
Views: 202,021
Posted By Bad Inferno

My New V-one Siii

Just built my new SIII....OH why have I been poring money into my SII to try and match this performance. With just running in the engine (very light on throttle) I managed to beet my average lap...
Forum: Nitro On-Road
04-29-2005, 04:39 AM
Replies: 4,584
Views: 202,021
Posted By Bad Inferno

Stinger size ver power band

I run a touring car (Kyosho v-one SII) with novarossi CX12P and Nova pipe. I just put on a silicon extender on my exhaust stinger (3/4" length) to deflect the oil away from my rear tire and body...
Forum: Nitro On-Road
04-24-2005, 05:57 AM
Replies: 4,584
Views: 202,021
Posted By Bad Inferno

Nova CX12P

Chaya
My v-one SII has a Nova CX12P uses a v-one R two speed with 16/20 45/49 combination.

Nova pull start does not fit very well
Forum: Nitro On-Road
04-22-2005, 05:40 AM
Replies: 4,584
Views: 202,021
Posted By Bad Inferno

Clutch

It does not line up well and you maybe able to see a spacer between the clutch and the nut where the shoe spring has to sit. this was so the pinoin and spur lined up. trouble with moving the engine...
Forum: Nitro On-Road
04-22-2005, 04:44 AM
Replies: 4,584
Views: 202,021
Posted By Bad Inferno

Clutch

No its the v-one R clutch I think.
Forum: Nitro On-Road
04-17-2005, 04:03 AM
Replies: 4,584
Views: 202,021
Posted By Bad Inferno

Exhaust

Oops sorry..If you drive like me and when you hit something instead of your stinger bending it allows the exhaust to move into the car by 1/2" and the spring takes some of the impact.
Forum: Nitro On-Road
04-17-2005, 03:42 AM
Replies: 4,584
Views: 202,021
Posted By Bad Inferno

3 shoe buggy clutch on novarossi

Just stumbled across this thread and thought I would share my V-one SII...I know I will be able to learn alot

Pics of my car and a shot of a Cheap but good modification.. can lengthen the life of...
Forum: Australian Racing
02-11-2005, 08:18 PM
Replies: 3,021
Views: 206,988
Posted By Bad Inferno

Foams

When you find the shore you want have a look at www.rcmart.com or rcsquare...they are about US9.00 each and they get here in about 7 days. or rcsquare have them on ebay and the shipping is about...
Forum: Australian Racing
01-29-2005, 04:33 AM
Replies: 3,021
Views: 206,988
Posted By Bad Inferno

Dandy Track

I have not been able to follow all the "track moving" story thus far however will the new track at the show grounds be marked out and available for practice as the existing one is. I am definatly...
Forum: Electric Off-Road
04-12-2004, 05:42 AM
Replies: 5
Views: 773
Posted By Bad Inferno

I ran the novak in my TA04 whcih went well until...

I ran the novak in my TA04 whcih went well until the shaft come away from the magnetic rotor....Novak DO not sell spare parts for these motors.

I also use the onboard data logger which recorded...
Forum: Australian Racing
04-12-2004, 05:29 AM
Replies: 0
Views: 821
Posted By Bad Inferno

Need some setup help for SERCCC Dandy Buggy

New to Nitro buggies (did run electric onroad) I would appreciate some help in buggy setup...

Currently run an inferno 7.5 with Kanai shocks (blue medium springs) 40wt/35wt F/R oils, anti sway...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.