R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: trf211
Showing results 1 to 25 of 500
Search took 0.05 seconds.
Forum: Electric Off-Road
03-05-2024, 10:57 AM
Replies: 1,506
Views: 298,933
Posted By trf211

Just to be clear I'll explain why I made some of...

Just to be clear I'll explain why I made some of these changes. The past month I started on the kit setup which was decent, in my opinion too soft on the front end and too stiff on the rear end. You...
Forum: Electric Off-Road
03-05-2024, 04:08 AM
Replies: 1,506
Views: 298,933
Posted By trf211

My base setup for sdrc. 18mm, +2 axle and...

My base setup for sdrc.

18mm, +2 axle and diff height, kit springs kit pistons kit eyelets, 32.5wt front 30wt rear, 5° caster, +1 HT steering, center center C/D, shock positions front-2C, shock...
Forum: Electric Off-Road
02-01-2024, 10:56 PM
Replies: 434
Views: 110,777
Posted By trf211

Trust me I understand where you're getting at,...

Trust me I understand where you're getting at, skill overrides everything, it always will. All I was suggesting is the larger battery will have less voltage sag during load. It will always feel...
Forum: Electric Off-Road
02-01-2024, 09:53 PM
Replies: 1,506
Views: 298,933
Posted By trf211

Setups in general can be subjective, however I...

Setups in general can be subjective, however I preferred the extra antisquat for clay on the box stock buggy after trying both. Easy to test, only 2 screws.

I have to say after building a b6...
Forum: Electric Off-Road
02-01-2024, 01:39 PM
Replies: 434
Views: 110,777
Posted By trf211

For stock racing on clay I suggest using the...

For stock racing on clay I suggest using the largest battery you can with the highest C rating. A national racer at the track here uses 6400mah shorty across all stock platforms, lowering the CG ever...
Forum: Electric Off-Road
02-01-2024, 10:23 AM
Replies: 1,506
Views: 298,933
Posted By trf211

It doesn't list the quantities btw, just sizes...

It doesn't list the quantities btw, just sizes but I can upload one soon...
Forum: Electric Off-Road
01-31-2024, 11:30 PM
Replies: 1,506
Views: 298,933
Posted By trf211

~77mm front and rear

~77mm front and rear
Forum: Electric Off-Road
01-31-2024, 12:06 PM
Replies: 1,506
Views: 298,933
Posted By trf211

Definitely. A few dozen just showed up at the...

Definitely. A few dozen just showed up at the local track, going to be a busy day today
Forum: Electric Off-Road
01-16-2024, 12:10 PM
Replies: 1,506
Views: 298,933
Posted By trf211

If you look at the b7d photos you can see a...

If you look at the b7d photos you can see a button head screw recessed into the motor plate just under the spur, and another is just barely visible on the rear portion of the spur in the rear hub/arm...
Forum: Electric Off-Road
01-15-2024, 06:29 AM
Replies: 1,506
Views: 298,933
Posted By trf211

Never realized it until now, sorry if someone...

Never realized it until now, sorry if someone else has pointed it out already, but has the diff been moved slightly further back in the chassis compared to the b6? That close up of the gearbox and C...
Forum: Electric Off-Road
01-13-2024, 07:18 AM
Replies: 1,506
Views: 298,933
Posted By trf211

Wish they'd bring back the Elite model of bodies...

Wish they'd bring back the Elite model of bodies as well, think they would go well with these newer chassis.
Forum: Electric Off-Road
01-04-2024, 11:28 PM
Replies: 434
Views: 110,777
Posted By trf211

The machined spacer set for the shocks. Maybe the...

The machined spacer set for the shocks. Maybe the vertical ballstud mount for the rear shock tower. Other than that you'll be set with your list of stuff
Forum: Electric Off-Road
01-03-2024, 01:47 PM
Replies: 180
Views: 37,155
Posted By trf211

Beware the 6240 servo listed in the hopup section...

Beware the 6240 servo listed in the hopup section of the Losi website is incompatible. The servo gear is around 2.5mm further forward than the promoto servo, the geometry of the steering gets thrown...
Forum: Electric Off-Road
12-10-2023, 08:34 AM
Replies: 180
Views: 37,155
Posted By trf211

We've been abusing the hell out of them, so far...

We've been abusing the hell out of them, so far it seems like just the battery box and rear crash fender assembly are wise spare parts to keep around. It is extremely durable on dirt, I cannot...
Forum: Electric Off-Road
12-05-2023, 06:46 PM
Replies: 180
Views: 37,155
Posted By trf211

After spending a few weeks driving promotos on an...

After spending a few weeks driving promotos on an offroad track with banked corners, it handles banked corners perfectly. There is no issue whatsoever.

The bikes come with 3 different roll bar...
Forum: Electric Off-Road
10-26-2023, 11:49 PM
Replies: 434
Views: 110,777
Posted By trf211

On the tower side. Using the optional vertical...

On the tower side. Using the optional vertical ballstud mount shown here in blue....
Forum: Electric Off-Road
10-26-2023, 08:44 AM
Replies: 434
Views: 110,777
Posted By trf211

This HRC setup should favor lower traction...

This HRC setup should favor lower traction surfaces, and tune slightly towards a LRC when traction gets high. In the kit configuration the rear of this buggy is setup on the LRC side in my opinion...
Forum: Electric Off-Road
10-18-2023, 08:23 AM
Replies: 434
Views: 110,777
Posted By trf211

My guess is he was trying different settings on...

My guess is he was trying different settings on the vertical mount during the event and settled back on 2.5mm. Instead of fishing out a shorter ballstud and locknut for the horizontal ballstud...
Forum: Electric Off-Road
10-17-2023, 06:57 PM
Replies: 434
Views: 110,777
Posted By trf211

According to photos of his buggy and the setup...

According to photos of his buggy and the setup sheet via petitrc, David was running 4mm on the vertical ballstud mount.
Forum: Electric Off-Road
10-14-2023, 03:32 PM
Replies: 434
Views: 110,777
Posted By trf211

The .2 doesn't really need much to be...

The .2 doesn't really need much to be competitive. As with all AE buggies, the machined spacers for the shocks are the first thing to consider. If you're buying it used they could already be...
Forum: Electric Off-Road
09-30-2023, 09:49 AM
Replies: 75
Views: 14,206
Posted By trf211

Does the kit come with that body foam?

Does the kit come with that body foam?
Forum: Electric Off-Road
07-02-2023, 10:34 PM
Replies: 180
Views: 37,155
Posted By trf211

Years ago I remember the HPI savage had a quad...

Years ago I remember the HPI savage had a quad body that was like that. Fun concept.
Forum: Electric Off-Road
04-02-2023, 12:35 PM
Replies: 434
Views: 110,777
Posted By trf211

I'm on dirt but so far it seems less initial,...

I'm on dirt but so far it seems less initial, more + smoother mid corner. Easier and predictable to drive. I like the +2.
Forum: Electric Off-Road
02-23-2023, 02:36 PM
Replies: 9
Views: 2,011
Posted By trf211

I think your ps48 body might have been too thin...

I think your ps48 body might have been too thin of an initial layer or not as even of a coat as you might have expected. I use 48 a lot and I've found what you've described to happen when I go too...
Forum: Electric Off-Road
02-23-2023, 10:16 AM
Replies: 434
Views: 110,777
Posted By trf211

Any feedback on the new steering plates?

Any feedback on the new steering plates?
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.