R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Radio and Electronics (https://www.rctech.net/forum/radio-electronics-137/)
-   -   Futaba 4PX (https://www.rctech.net/forum/radio-electronics/809530-futaba-4px.html)

Dino_D 04-21-2016 08:31 AM


Originally Posted by JAE (Post 14499917)
Can anyone describe with first hand experience, what the new software does for the speed/functionality of the remote? will I notice a differnece? I'm coming from a 4pskr btw thx

The new software allows for race mode similar to the 4PX-R. It gives slightly better response times with telemetry turned off. I had the 4PKS-R and I like the feel of the 4PX. Even more so with the new RACE mode. Again, you can feel a bit of a difference with race mode on and off. But it also gives you an option to slow the response down as well. This might be useful if you have trembling hands when you race. You can actually see the wheels tremble. LOL. But again, it depends on your servo speed as well. I try to get servos that are 0.08s or faster.

If you want to compare response, there is no actual value posted on response time, but it is quicker than the 4PKSR for sure. Futaba says 30% quicker than the 4PKSR.
But no hard values on response times.

JAE 04-21-2016 09:12 PM

204gfe receiver vs 304sbe
 
Aren't these the same frame rate.? Is there a difference in the actual speed once installed? Anyone use both? I was told they are the same speed but 204 doesn't have telemetry, which was what I thought I had found myself. Thx much


Originally Posted by jhautz (Post 13933253)
204 receivers work, but the fastest frame rate comes with the 304. Also, the 304 has the ID code in the receiver so the car can't be run with the wrong model selected in the radio. Like spektrum has been doing all along. With the 204 if you turn on 2 cars with the 204 Rx the radio will run them both at the same time. With 304 receivers only the selected model runs.


kifidis 04-30-2016 03:02 PM

Hi guys

Im using hobbico life 2s 1900mah battery on my 4px i control the 4px settings when first plug the life batteries almost every 2 min drop it 6.6 6.5 6.4 and alarm set 5.8v @life select.

is it normal i think no how can i race with this pistol

what should i do? whats the avarage working hour with life 1900mah ty

kifidis 05-01-2016 04:26 PM

?

Iggy 102 05-01-2016 05:22 PM

Sd card
 
Has anyone had problem with it going into update mode when holding end and turning on to do update?

WesRaven 05-02-2016 12:56 PM


Originally Posted by kifidis (Post 14512806)
Hi guys

Im using hobbico life 2s 1900mah battery on my 4px i control the 4px settings when first plug the life batteries almost every 2 min drop it 6.6 6.5 6.4 and alarm set 5.8v @life select.

is it normal i think no how can i race with this pistol

what should i do? whats the avarage working hour with life 1900mah ty

Sorry I can't help you with the life battery, haven't tried one yet. To give you something to compare to I run a 2200 5 cell NIMH pack and generally get around 6-7 hours of usage before its time to recharge. I keep track of the time by using the Total Time feature in the System/Time menu, but haven't paid attention to how quickly the voltage drops.

jhautz 05-02-2016 03:13 PM


Originally Posted by kifidis (Post 14512806)
Hi guys

Im using hobbico life 2s 1900mah battery on my 4px i control the 4px settings when first plug the life batteries almost every 2 min drop it 6.6 6.5 6.4 and alarm set 5.8v @life select.

is it normal i think no how can i race with this pistol

what should i do? whats the avarage working hour with life 1900mah ty

I usually recharge mine every 2-3 race days. Something seems wrong if you see voltage drop that quickly. Maybe a bad cell in the life pack?

kifidis 05-02-2016 04:31 PM

When I asked customer service they said that due to the chemical structure of life battery , and check my life battery cell everythings ok

Life battery drops so fast 6.5 6.4 6.3 and stop and drop down so slowly.

This is information dont worry about this situation.


but still I think it is ridiculous top end surface transmitter and throw money about battery.:sneaky:

AreCee 05-02-2016 04:51 PM

I'm using a LiFe battery that's about three years old and it holds it's charge for four race days at least. I'll recharge once the voltage drops below 6.5.

The battery has seen use in my 4PL and now in the 4PX. Voltage drop seems a bit more in the 4PX.

kifidis 05-02-2016 06:03 PM


Originally Posted by AreCee (Post 14515438)
I'm using a LiFe battery that's about three years old and it holds it's charge for four race days at least. I'll recharge once the voltage drops below 6.5.

The battery has seen use in my 4PL and now in the 4PX. Voltage drop seems a bit more in the 4PX.

which battery do you use and your battery drop down like a 1 min 1v till the coming 6.5 or 6.4

chewy78 05-03-2016 10:29 AM


Originally Posted by cutting42 (Post 13981272)
Possibly a little unfair. the PX is the first radio I am aware of that supports multiple RX technologies. The new T-FHSS, FHSS, S-FHSS and C2 FASST. The only unsupported is the C1 FASST.

I bought one as I could use all my old RX as well as the new fast T-FHSS.

The Orange R400F is C1 and C2 compatible so should work with the PX and is cheaper.

thats good to know i just bought a new 4px from tower hobbies for 450 with coupon

Dino_D 05-04-2016 08:23 AM


Originally Posted by kifidis (Post 14512806)
Hi guys

Im using hobbico life 2s 1900mah battery on my 4px i control the 4px settings when first plug the life batteries almost every 2 min drop it 6.6 6.5 6.4 and alarm set 5.8v @life select.

is it normal i think no how can i race with this pistol

what should i do? whats the avarage working hour with life 1900mah ty

My hobbyking Life last like 2-3 weekends of racing. Maybe your pack has a problem.

wichitafc98 05-06-2016 07:18 PM

I am having problem with 1.3 upgrade. It freaks out the screen any thoughts? Or anyone else have that issue.

JayL 05-09-2016 09:09 AM

Mine with 1.3 is fine

Dino_D 05-09-2016 09:47 AM


Originally Posted by wichitafc98 (Post 14521413)
I am having problem with 1.3 upgrade. It freaks out the screen any thoughts? Or anyone else have that issue.

What do you mean by freaks out?

You have to copy the firmware file into the futaba folder. Make sure there is not other subfolder within the futaba folder


All times are GMT -7. It is currently 08:43 AM.

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.