Originally Posted by mjdliaw (Post 7785440)

Dear RC guy I have a problem with my M11X. The problem is I can't switch it on, totally black out. I don't know why? Is there anyone can help me up? Or can anyone can let me know where can I send it for reply? Badly need help from your all. I m staying at Malaysia.

Originally Posted by mjdliaw (Post 7785440)

Dear RC guy I have a problem with my M11X. The problem is I can't switch it on, totally black out. I don't know why? Is there anyone can help me up? Or can anyone can let me know where can I send it for reply? Badly need help from your all. I m staying at Malaysia.

Originally Posted by Mr. Bojangles (Post 7666009)

The first versions of the M11x came with a reciever only rated for 6.0v. The new ones i'm pretty sure come with the 451 receiver and will handle more power

Originally Posted by Fred Perkins (Post 7355921)

Yes no self discharge at all

Originally Posted by ALG (Post 7786061)

Hi,
is this receiver the same as the 451R???
http://www3.towerhobbies.com/cgi-bin...&I=LXYXA7&P=ML

My question is because I got my M11X last April and would like to know if I can use it with LiPo and NO regulator.

Thanks for the help

ALG

Originally Posted by F18engineguy (Post 7742863)

Ok, as you can see I have the servo all the way back and there is just little room for the ball stud. I have shimmed up the ball stud so it sits little higher; in addition, I cut a flat on the ball joint as well so that is has even more room. Short of grinding on the case (which I will not do) this was the only way I could get enough clearance. For illustration presupposes you can see in the one photo where I have the ball stud half way out how close everything sits. It works, but I am a bit disappointed that they would need to make this servo so big. It is my understanding that this is the servo that Ryan Cavalleri runs in his B4.

Thoughts?

Originally Posted by Jmuck69 (Post 7786697)

What is the benefit of the 451R? i just got a M11x.

Originally Posted by BLKNOTCH (Post 7785879)

Please be sure you are not using your battery from an older m11 as the voltage is different, the m11x runs on 7.4 volts where the older m11 ran on 12volt approximate so it you were trying to use an extra battery you had then it will not turn on.

Just a thought to try to help, also be sure the red wire on the battery plug is in the center.

Good luck
Sean

Originally Posted by icemandolmite (Post 7790406)

does the 92624 fhss-2 reciever work with m11x?

i cant get it to bind

Originally Posted by killermmn (Post 7786507)

you have to send back to sanwa in japan!

Originally Posted by aswalex (Post 7796165)

Bro do you know how to send M11X back to Japan?

Originally Posted by KWT-NITRO (Post 7800585)

hello,

can i run High Voltage servos with lipos directly on my M11X rx?? or do i have to buy the new SSR rx??


cheers
Ali