This should help. Look at the bottom. I havn't played with plugs but maybe I should.

http://www.novarossi.it/2012/index.p...-p5-tuned.html

I've raced the #6 plug when ambient air temps were in the 20's through the 90's F and my engines ran fine. My rule of thumb is to run the engine on the #6 turbo plug, if it runs good...stick with it. Obviously there are other factors than air temp such as humidity, altitude, etc. That said, in the past 4 years racing Novarossi engines I changed plug type once...it was in the high 90's with extreme humidity. As per the chart, you would run the colder #7 plug...completely the opposite, the extreme moisture required a hotter plug and the #5 was money.

The temp range for the #6 as per the Nova chart is roughly 50-80F. As for the tune, again there are other variables so my rule of thumb if you change plug temp is run it with existing needle settings...then tune from the engines look, feel, sound, etc. But to answer your direct question, if anything you may have to richen when going to the hotter plug.

Hope this helps...best of luck with your new P5.

Thank you Chris and Scrapz. I love my P5 so far. I just have to learn more about some things to keep it solid in the future.

Does anybody know if you can use Werks #5 and #6 plugs with the Nova S21P5XLT?
Thanks in advance.

hi
 

Ok the plugs are c5tgc is hot, c6tgc medium, c7tgc cold

a C6tgc works fine in the temps you said although above 90 I would try a c7tgc just to keep it from burning up unless its humid outside then stay with the c6tgc.

I called Novarossi last year and spoke with someone at length about this very thing. The gist of the conversation was that higher temps require a colder plug, and the referred me to their temperature chart. http://www.novarossi.it/2012/index.p...-off-road.html
But when I asked Adam the same question, he said that he doesn't change the plug for temps. He told me that humidity plays more of a factor than temp does. I'm still kinda confused about the whole subject, but as evidence of what Adam said being right (as if he needs evidence when it comes to tuning engines), when it was 95-100 degrees at AMS 5.0 in Alabama last year, I'm pretty sure that Adam, and most guys too, still ran the C6 plug. Many of us had tuning problems, and suffered multiple flame outs, but when I asked Adam afterwards, he said that you needed to tune the motor inside of the building, where the humidity was probably 100%, instead of outside, where it was 20-30% less humid.

Things are as clear as mud to me now!

yes

Thank you Sir!

We tend to run all year round all over Australia using the C6TGC without any problems, Temps ranging from 45F - 105F, I know this is well outside the Novarossi chart range but we don't suffer any problems

There no doubt should be benefits to running a cooler plug when its hot (specially if humidity is low) so i might experiment with using the C7TGC on the hot days (say above 32/35c - 90-95f) and see what we find




Dave'
FUSION X ENGINES AUSTRALIA

I'll just leave 'is rye cheer

http://www.rctech.net/forum/r-c-item...lus-21-4c.html

I keep saying that I'm going to experiment with a cooler plug in high temps, but I never actually get around to it. What about extremely high humidity days....do you run a hotter plug (C5)?

Run a colder plug in higher temp, but, if the humidety is very high, it`ll be smart changing to slightly hotter plug.

New line of engines at Nürnberg.. Meet the Mitos...

http://www.neobuggy.net/

Hey guys, just trying to sift thru all the bullcrap. Some say the Odonnell plugs are awesome and great, and a few say dont use them, they fail, the coil could drop in, not last yadadadada

Any thoughts on this?

I like the O'Donnell v2 plugs. I've been using the 277T with a lot of success.

A lot of people use the 97T, but I wasn't a big fan. I did have a bunch of these fail on me.

But on my race engines, I still run a Nova plug. They seem to be the most reliable.