ummmmmm ......................... new pretty head ;)

keep checkin back :)

thanks jon


dont forget to leave a testimonial on www.houstonsengineservice.com ;)


houston

novarossi plus21-7fms
 

I got the 21-7fms that I only have 3/4 of a gallon of fuel through it.I went to the track for the first time to finish break-in and have noticed oily dirt collecting around the rubber boot on the carb and at the base of the carb.It's only a small amount and just need to know if it's anything to worry about.

Just wanted to say thanks Monty for the getting the head buttons out to me in good order.

from me ?

if its from me it is probably just the lubrication that i use to assemble the engine . it will collect a little dust ;)

Got it from Amain. I've been breaking it in on the street and haven't noticed any problems until I got it in the dirt.

Monty, what do you think of the Novarossi N21BF Limited Edition .21 Off Road 3 Port motor???

I wanna up that question with.....What do you think about it in a truggy?

Monty, what do you think of the Novarossi N21BF Limited Edition .21 Off Road 3 Port motor???
__________________

I wanna up that question with.....What do you think about it in a truggy?

I can answer that, I have one of monty's, the motor just rips, it will pull a truggy around pretty good, lacks a little on the top, but a great mill for the $$.

jlo

Speaking of flat head screws and Hudy tools.....what is the best Hudy tip for the Novarossi screws on the head and back plate?


I have a dynamite tool set, and I'm replacing my tips on my most used wrenches with Hudy tips.

any of these??

http://www.amainhobbies.com/product_...c-40mm-x-150mm

http://www.amainhobbies.com/product_...c-30mm-x-120mm

http://www.amainhobbies.com/product_...c-50mm-x-150mm

thanks

Me too. I just found this thread and didnt realize you sold the motors already modded. :cry: I just ordered one last week for my D8T and decided to do a search to see how it would run in my D8T and came up with this thread. I know that it has great low end and somewhat falls off on top, I have a Dynamite 086 pipe that I'm going to use with it hopefully that helps. If I sent it to you for "service" what could I expect when I get it back, better top end?

So it's 155.00 for the modded engine or the normal one? I'd love to run another one of these modded of course in truggy.

yes ;)

enquire through www.houstonsengineservice.com for sales guys

the mods get a little tweaked on here .