what ever happened to patient confidentiality !!!!!!!! bloody doctors :deathstar

shane how is that motor going ?

Yes it will fit fine, all Go .21's will interchange. The sport case has a 25mm bearing instead of the 25.4mm in the race models. Also the case on the sport does not have the cuts milled in it above the rear bearing, may be a slight decrease in power. A bigger factor may be the case on exhaust port might not be tall enough on the sport case. It will run just fine, performance may be a little less though.


Rex

LMAO, Nice! :lol::lol:

It arrived back on tuesday after some massive mods tlc (mark replaced both bearings, p/r/s, crank and gave it a rough tune). :D

Went and got a complete clutch setup for it today so i now have 2 engines complete with clutch's on so if anything happens to either of them on race day its only a 5min job instead of 30 to change them over.

Won't be able to get a tune on it before sunday so i'll race with the alpha and hopefully get a tune on the go sometime nextweek.

A MAin Fuels will be avail at MOTORAMA :D:D:D

Any questions please don't hesitate !

Cheers MM

thank you all guys.

thanks lowlife88.. for the help

today Go GX-5R go "in Stock" at amain hobbies and as fast as i can, i got mine!

Yes, amain should be well stocked for a bit. I did just receive an order for a few parts, etc.

Also, moto has a large shipment of parts on the way.

now i need to choose a good pipe... but will not buy now...

what pipe do i have to use?

i'll race 90% of time at this track:

http://i26.photobucket.com/albums/c1...zero/pista.jpg

thanks again

EFRA 2072 on the 5-port will be DIALED.

+1. thats a great combo. cant wait to get some more nitro threw mine/

the 2072 will provide the best overall performance for sure from start to finish :nod:

im working on a Go tech 3R and need to replace the HSN and LSN gasket . I found this one but im not sure if it will work for both are the ydifferent ?
Link

they will get u going, or these will last longer : -http://www.massivemods.com.au/produc...roducts_id=207

cut some silicon fuel line to the thickness of the o-ring,and install. Works perfect. And buy the ones from massive mods. They last forever.