I think that GO already switched to the short L.S. needle
in the newer motors.

I just ordered a Go 7 last week. It came with the old LSN I believe. Either way, I don't have any problems tuning.

ive emailed racefactor twice about the lsn problem on my 3 port r and never got a responce

here is a pic of my go .21 3 port race engine and where the settings are with the go carb thnx will g

Who did you buy the motor from?

Will G....does that motor run decent that way?

that motor ran almost all 2 hours of the endurance race like that but the first 15 mins when it lean bogged and we adj to what you see. also i have a novarossi 9886 pipe with standard header and odonnell 77t plug was 279 when came off after 2 hours but found that the exhaust side fuel line came off and im sure leaned it out abit. other than that it had tons of bottom end and pretty ok top

ebay store pbloverz/luisev
bought it feb 27 2008

I have never heard of anyone having trouble getting ahold of Russell or Dana, maybe you had the wrong e-mail address?
If you send me your Lsn I'll rework it for you for free. e-mail [email protected]

Rex

Hey guys I picked up a turbo 5 port and need to break it in. I picked up a p3 plug for it and it has no brass washer like regular plugs. Since this is my first turbo engine I just wanted to make sure there is no washer on turbo plugs. Also any tips on needle settings for breakin? Im gonna try to find some 30% but if I cant I may have to run 20%. Thanks

Nope, turbo plugs don't use washers. Not sure what the needle settings are for the 5 port.

To break-in my 5 port I had the HSN flush and the LSN 1-1.5 in from flush. Good luck.

Make sure you have a real strong starter box and heat that baby up with a hot air gun or powerful hair dryer otherwise you will struggle to turn it over. The 5 and 7 port Go Techs have mega pinch when new. Check out the break in procedure on the bottom of page 78 on this forum. Follow this and you will be sweet. Those needle settings are spot on for break in. After 15 tanks or so you can start leaning the LSN toward 2.5 turns in from flush for normal running.

Here's a little video my wife took from round 4 of our points series here in Bama. I'm running my PTM Go 3R with approx. 4 gallons on it.....and I'm the slow red car.


But I did finish 2nd.................




http://www.youtube.com/watch?v=c97czXcEv1s

you must race with some verry slow people then