Seattle RC Racers/Hangar 30
Caveat emptor: Some years ago, amb updated its system, which rendered MRT transponders in circulation at that time obsolete. MRT subsequently reverse engineered their transponders to work on the updated system. It took a year or two. If your MRT is purchased new within the past five or so years, it will work. Thankfully it has been rare, but I have had racers present me with MRTs bought cheap on EBay that did not work. You can appreciate transponder risk is on you.
Tech Elite
iTrader: (16)
Hey All,
We are about 24hrs from "go on the tone". Just a reminder about pit set up, 2 racers per 6' table. It's a good idea to toss in a chair when you load up tomorrow. We had some folding chairs fail last season and need to take inventory. This program is on a tight schedule with a paid window of time at Hangar 30; 6p-10:30p. Doors open at 6 with track set up usually ready by 6:25 followed by open practice until drivers meeting at 6:50. First heat goes off at 7 sharp. 2 rounds with a re-sort, single mains, and then tear down. Expected classes: USGT, GT12-r, Stock 12 and Novice. Entry fees are $30/10 and can be PayPal'ed. Hope y'all are ready to get your Wed Nite Worlds on!
Made a mistake on entry: $30/10!
We are about 24hrs from "go on the tone". Just a reminder about pit set up, 2 racers per 6' table. It's a good idea to toss in a chair when you load up tomorrow. We had some folding chairs fail last season and need to take inventory. This program is on a tight schedule with a paid window of time at Hangar 30; 6p-10:30p. Doors open at 6 with track set up usually ready by 6:25 followed by open practice until drivers meeting at 6:50. First heat goes off at 7 sharp. 2 rounds with a re-sort, single mains, and then tear down. Expected classes: USGT, GT12-r, Stock 12 and Novice. Entry fees are $30/10 and can be PayPal'ed. Hope y'all are ready to get your Wed Nite Worlds on!
Made a mistake on entry: $30/10!
Last edited by Slapmaster6000; 09-27-2022 at 03:36 PM.
Tech Elite
iTrader: (21)
Few questions for tonight as it's been quite a long time since I've raced H30:
1) I gather that tables are provided? I threw one in my car just in case, but wanted to confirm. Brought a chair too of course.
2) Power is available?
And some 1/12th rubber tire questions, as this did not exist the last time I touched a pan car:
1) Glue the sidewalls?
2) Do they need re-truing/scuffing?
3) Saucing regimen - how long, when to wipe, clean/not clean between runs, what to clean with if so, etc.
Thanks! Hopefully I can still get around the track.
1) I gather that tables are provided? I threw one in my car just in case, but wanted to confirm. Brought a chair too of course.
2) Power is available?
And some 1/12th rubber tire questions, as this did not exist the last time I touched a pan car:
1) Glue the sidewalls?
2) Do they need re-truing/scuffing?
3) Saucing regimen - how long, when to wipe, clean/not clean between runs, what to clean with if so, etc.
Thanks! Hopefully I can still get around the track.
R/C Tech Elite Member
iTrader: (28)
Few questions for tonight as it's been quite a long time since I've raced H30:
1) I gather that tables are provided? I threw one in my car just in case, but wanted to confirm. Brought a chair too of course.
2) Power is available?
And some 1/12th rubber tire questions, as this did not exist the last time I touched a pan car:
1) Glue the sidewalls?
2) Do they need re-truing/scuffing?
3) Saucing regimen - how long, when to wipe, clean/not clean between runs, what to clean with if so, etc.
Thanks! Hopefully I can still get around the track.
1) I gather that tables are provided? I threw one in my car just in case, but wanted to confirm. Brought a chair too of course.
2) Power is available?
And some 1/12th rubber tire questions, as this did not exist the last time I touched a pan car:
1) Glue the sidewalls?
2) Do they need re-truing/scuffing?
3) Saucing regimen - how long, when to wipe, clean/not clean between runs, what to clean with if so, etc.
Thanks! Hopefully I can still get around the track.
they got power. bring an extension cord.
for GT12R -- IDK, never ran the class, but this is what i know. front outer sidewall gluing shouldn't be needed UNLESS on high grip. truing won't be needed (unless again on high grip). sauce -- SXT or TDK.
Honestly, there isn't enough sidewall on those GT12 tires to glue
Bummed I missed the first race, had some fires to put out. Next race, USGT drivers watch out.....
Bummed I missed the first race, had some fires to put out. Next race, USGT drivers watch out.....
Tech Elite
iTrader: (21)
That was a lot of fun
Thanks PutAwayWet and the rest of the crew for the efficient program. Light turn out, but wow was it nice to get a lot of racing done in a short amount of time. I'll do my best to make it out a few times this season on those Wednesdays were my in office work schedule in Tukwila aligns.
Tech Regular
iTrader: (15)
Disappointed I couldn't make it on Wed; planning again in 2 weeks.
New to USGT::
Any ROAR 25.5T motor: can be adj timing, doesn't have to be FT?
Also, new to 25.5T, what FDR gearing is about right?
I see 2 types of tires on the USGT Gravity website: belted and unbelted; which do you run?
Thanks.
New to USGT::
Any ROAR 25.5T motor: can be adj timing, doesn't have to be FT?
Also, new to 25.5T, what FDR gearing is about right?
I see 2 types of tires on the USGT Gravity website: belted and unbelted; which do you run?
Thanks.
Last edited by Dread Pirate; 10-01-2022 at 09:14 PM.
Thanks PutAwayWet and the rest of the crew for the efficient program. Light turn out, but wow was it nice to get a lot of racing done in a short amount of time. I'll do my best to make it out a few times this season on those Wednesdays were my in office work schedule in Tukwila aligns.
Disappointed I couldn't make it on Wed; planning again in 2 weeks.
New to USGT::
Any ROAR 25.5T motor: can be adj timing, doesn't have to be FT?
Also, new to 25.5T, what FDR gearing is about right?
I see 2 types of tires on the USGT Gravity website: belted and unbelted; which do you run?
Thanks.
New to USGT::
Any ROAR 25.5T motor: can be adj timing, doesn't have to be FT?
Also, new to 25.5T, what FDR gearing is about right?
I see 2 types of tires on the USGT Gravity website: belted and unbelted; which do you run?
Thanks.
On tires, from the current rule set: CARPET p/n GRC123 (GRAY wheels) set of 4 available through Gravity RC http://www.teamgravityrc.com/ to dealers and retail.
Tech Elite
iTrader: (21)
Where do the videos from the mains get posted?
Was great to see you out again, Pete. To this day, one of the best races I ever called was a duel between you and Kody at the Hangar. Work that schedule, and accept no excuses from Wes, either!
Indoor USGT is any ROAR-approved 25.5t brushless motor. All other standard USGT rules apply.
On tires, from the current rule set: CARPET p/n GRC123 (GRAY wheels) set of 4 available through Gravity RC http://www.teamgravityrc.com/ to dealers and retail.
Indoor USGT is any ROAR-approved 25.5t brushless motor. All other standard USGT rules apply.
On tires, from the current rule set: CARPET p/n GRC123 (GRAY wheels) set of 4 available through Gravity RC http://www.teamgravityrc.com/ to dealers and retail.
Tech Adept
Any luck with 21.5 TC this year?
Tech Elite
iTrader: (21)
Peter I have a spare set of Jacos for you if you are .4 up on me again 😉. Jokes aside I don't think anyone will be complaining about tires.