I was told that these were pre-production, and I have no knowledge of the testing protocol.
I agree with you about the Mugen cvs.

Good, good... Let your darkside shine !

How many Ti screws did you get?

So they did not use it in their cars during racing at the Wintenats?

Well after thinking about it instead of keeping my r40 I am going to get another 710 to practice and spare parts.
What other shocks can I use in this car I tried the super HPI ones but they only fit in the front. Are there any aluminum ones out there that fit

You can't drive, You can not set the car !!So, What you want to say ?

I talk rubbish !

Hey Mr. Chan, what is that 951R-C and 715R-C? Any pics to show us?

Use only Serpent shocks ! That way you can follow the setups provided by Team drivers pretty much easily.

You can change the stock composite shock bodies to aluminum ones. 909410 for front and 909411 for the rear.

gee you sound like Simon Cowell in American Idol!! "She bangs, she bangs"

I just prepared to get ready for a new one ..So if they come out, I don't need to change my below text ..


Jokking only lah

I saw their cars, but didn't notice.

I got all the M3 non-tapping screws in Ti - still got a few more to replace, so I may end up saving 16 gramms

Dont make your car too light, unless you want to put some wings on it and watch it take off.

Then I'll have to paint my car like Julius does - KLM Blue and white

Almost done my car! I went to slide the second gear onto the shaft. I gave it a spin and it wobbles? Is it suppost to wobble? I have both bearings seated fully. Let me know what I should do here. Thanks.