Awesomatix A800/A800R
|
|||
#3856
Mmcx vs vtd
Hiya folks,
I have a a800x Evo which I run vtd with. The car is super fun to drive, but am wondering how it compares with the mmcx. I drive on a mid traction outdoor asphalt track.
I use the stock carbon chassis currently. I find that it has a bit more steering compared to the stock topdeck, but definitely not as much as I like.
I have a a800x Evo which I run vtd with. The car is super fun to drive, but am wondering how it compares with the mmcx. I drive on a mid traction outdoor asphalt track.
I use the stock carbon chassis currently. I find that it has a bit more steering compared to the stock topdeck, but definitely not as much as I like.
#3858
#3861
Could someone tell if makes big difference in case use middle motor conversion kit?
In fact i saw Machler in IIC only use MMCX to run in 17.5 class but Spec GT just run normal version car.
In fact i saw Machler in IIC only use MMCX to run in 17.5 class but Spec GT just run normal version car.
#3863
Tech Adept
#3864
Tech Initiate
#3866
The dot is going to vary on the tension and age of your belt. I think I have mine about one dot forward on the bottom. Make sure they are the same on both sides though. Check your steering degrees. I have mine set at 25 degrees. I had them set at about 32 degrees and was over-steering the car which caused a lack of front traction. When I pulled it back to 25 degrees it made a big difference.
I will try the belt setup. I have mine set on the top, not sure what this affects.
#3867
#3868
Tech Master
iTrader: (5)
Does anyone have P03 in stock???
Is there a way to remove P03 without damaging it?
I ordered a A21S ballstuds, but don't have enough spare P03 cups to put on all the new studs. Nobody seems to have them in stock. So I either need to re-use some P03 cups, or wait to install A21S until I can get them.
edit: Found P03's at Michaels Hobby in Florida. Still curious if there is anyway to remove them without damaging.
Is there a way to remove P03 without damaging it?
I ordered a A21S ballstuds, but don't have enough spare P03 cups to put on all the new studs. Nobody seems to have them in stock. So I either need to re-use some P03 cups, or wait to install A21S until I can get them.
edit: Found P03's at Michaels Hobby in Florida. Still curious if there is anyway to remove them without damaging.
Last edited by JeffC; 02-10-2019 at 03:23 PM.
#3869
Does anyone have P03 in stock???
Is there a way to remove P03 without damaging it?
I ordered a A21S ballstuds, but don't have enough spare P03 cups to put on all the new studs. Nobody seems to have them in stock. So I either need to re-use some P03 cups, or wait to install A21S until I can get them.
Is there a way to remove P03 without damaging it?
I ordered a A21S ballstuds, but don't have enough spare P03 cups to put on all the new studs. Nobody seems to have them in stock. So I either need to re-use some P03 cups, or wait to install A21S until I can get them.
I may never see them
#3870
Tech Regular
martin Paradis