Hugo

iTrader: (1)

I want the same aluminium sway bar holder.
Is it a pro4 option, if yes do you have the # number???

Thanks in advance.

rc-zombies

iTrader: (9)

pro4 has cf/plastic sway bar holders...

Rick Draper

The chassis on that car is the black carbon one with recessed cell slots not cut straight through it.

John Doucakis

iTrader: (1)

Can someone please list the parts (part numbers) needed to assemble a complete diff.
Thanks
John.

Hollowman

Damn Kingcrab where do i get some purple screws i saw it on that car and a page back also i am still waiting on my bulkheads but they have send them out yesterday and as soon it's arrive i can finish the car and race it i can't wait to see it perform on are dutch tracks, we soon see if the upperbulkheads really break that fast.

greetings hollowman

rc-zombies

iTrader: (9)

what's the largest spur gear I can put into this car....?

so assembly is going well.
chassis is prepped and CA'd.
rear diff went together nicely ... used 2 bearings instead of the spacer/bearing/spacer as per manual.
front one-way diff gear was a little tight... had to enlarge the hole just a hair.

also note that in the manual it states that the locked center pulley on the left side of the car...it is suppose to be on the right side and the one-way center pulley on the left... there was no addendum sheet with my manual.. on Japan website there is a photo of it.

s2

48dp is 80,and 107 in 64dp

Nexus Racing

New pics with the electronics installed:

axel

have you ran it yet?

HKRCMODEL

Yes Hara used 107T

S-T-R-l-K-E-R

hara used a 108t spur with a 29t pinion for rubber class at vegas

ngo8

how about for foam

HKRCMODEL

Yes thanks
made sure hara use 107-108 spur gear in cyclone now !
he b4 use 107T in reedy race of asia

rc-zombies

iTrader: (9)

I fitted a 108 spur last night... it fits fine.. other than it's about a hair before it petrudes the bottom of the chassis.

wagonman72

www.fastener-express.com