|
Originally Posted by UK.hardcore
(Post 12826663)
A Truggy T8g2 would leave you with 50mm by 57mm.
|
Originally Posted by Cain
(Post 12827163)
+1 great info.
Are the rates that will be available for the truggy available to be seen? Also, what length are the springs for the rear? |
Originally Posted by metoo
(Post 12826544)
Tekno,
What is the available footprint for an ESC after a truggy motor is installed? Also, what is the distance between the top of the front shock tower and the rear tower? Strange question...I know. The distance you are looking for is approx. 395mm. |
Originally Posted by teknorc
(Post 12827185)
Mamba Monster systems fit with about 4-5mm in between the ESC and motor. The ESC pad was made for Mamba Monster and smaller ESC's.
The distance you are looking for is approx. 395mm. Thank you greatly |
So tempting to get one of these bad boys. You tekno guys are making it difficult for me to save money lately :P
|
Originally Posted by spunkysandoval
(Post 12827303)
So tempting to get one of these bad boys. You tekno guys are making it difficult for me to save money lately :P
|
Hey Tekno,
In testing have you guys run a 2000kv truggy motor? If so what tooth pinion did you use? |
Originally Posted by spunkysandoval
(Post 12827303)
So tempting to get one of these bad boys. You tekno guys are making it difficult for me to save money lately :P
|
Originally Posted by metoo
(Post 12827169)
Hmmm..., the HW 150A ESC is 58mm long according to published specs. I sure hope you're off by a couple mm.
I had a HW150 in the EB48, but it was very tight. As in so tight that the sensor wire was basically sandwiched by the body/side guard, and on the other side the front center drive shaft is mm's from the ESC. That was the only config that would even fit with motor. I put a HW SCT Pro in there because I was afraid something would get damaged or shorted. I would go with a different ESC if I was you. Just not enough room for HW150. Too bad becasue I like the 150 also, great ESC. Works really well with Tekin motor! :) |
Originally Posted by Cain
(Post 12826716)
is this one of the super saver codes?
|
Originally Posted by skengines
(Post 12826857)
I used the Gold code to save 100.00. If you need the code, I can PM it to you but not sure if it will work.
|
Originally Posted by kawi650
(Post 12827676)
Aww, you have gone and made the entire company feel bad. Now apologize, buy the truck, and all will be forgiven. ;)
|
Yes tekno take my money
|
Have the eb48.2 upgrades been implemented into the truggy? Like the angled rear gearbox etc...
|
What it say its got all the upgrade the eb48.2 got
|
| All times are GMT -7. It is currently 11:34 AM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.