shoogoo?

we already do that, haha

yea it helps alot....but still with these SCT's its hard to keep bodies around for long....unless you just dont crash ever....and thats no fun. haha

shoo-goo and fiberglass matting:lol::lol:..I also line the inside of my lid with "Metal duct tape" it really helps alot with strenght and it is light weight also..

Does anybody happen to have the part number for the Losi thin 8-32 locknuts?
thanks
chuck

motor and speed control
 

Hey guys I am looking to buy a Mamba Max pro with a 5700 motor, will this be a good motor for the sc10?? And how would I gear it??

my SC10
 

Here is my SC10 with LPR 9.5 motor & EZRUN 60 :tire:

cont.
 

Some fuel tube & longer screws were needed to fit the bug

I'd like to know the answer to this one myself??

I was on the McMaster-Carr site and they had thin 8/32 nylon inserted locknuts for $2.32 per 100, I am not sure if these will work though. The height was 11/64.
chuck

are there any plans to release a ft kit?

I am waiting on the arrival of my sc10 and am looking for a front brace, is the RPM front brace and bumper pretty good? Whats everybody using? Thanks

I can't link it but Integy makes a "Alloy Hinge Pin Brace Set" for it that has the front brace and the rear piece your camber links attach to. That's what I plan to get.

RPM Front brace
 

RPM front brace is very good, although the bumper leaves something to be desired as far as looks.

Another optio is use the metal braces on the lower chassis.

Check back through the pages of this build thread, many posts about all of the information recently asked.

Use the tips and set ups and suggestions, and your trucks should be pretty dialed in for whatever use you may have in mind.

I think the RPM bumper looks rather good :nod: