I am going to be getting my SC10 within 2 weeks, i want to run Brushless Lipo but Im not sure what turn or Kv is competative for short-course classes. I have been running 1/8th nitro offroad for 8 years now, and want to do something different.

Thanks,
Dillon Hoffman

anything more then 13.5 and you will have traction problems.

17.5 is the way to go.

You can over power it like I did and dial it back at the track and open it up for the street and impressing friends. ;)

*

Same here, I just don't want to spend $250 on another brushless system. What do you guys recommend.

I apologize if this has been asked before on this thread, but which cvds are you guys using in your sc10s?
and my output drive cups are wobbly and create a horrible noise...any tips on fixing this up would be awesome.
Thanks.

Hey guys, I'm finally gearing up to get my SC10 on the track (been sitting there after I built it for about two months now).

What gearing do you guys recommend for a MM+4600Kv on a medium-sized, indoor clay?

im running the 5700 with 16/87 at WCRC & OCRC

try an 18/87??

yes, try 18/87. I get great motor temps and awesome battery life.

again, what cvds are you guys using?
can i get a link to where i can order them?

Wobbly? :weird: Check you bearings. CVD's really aren't needed, unless you really wanna spend your money.

I run the CVD's out of a t4. I noticed when I ran the stock bones that they wore out quickly. That is y I upgrade.

Same as me !!

your getting like 160-170 temps ?

Thanks a lot, I want to run LRP so should i go for the SPX Competition Stock Spec, Competition Spec, or Competition TC-Spec?
Also, I'll primarily be running at OCRC so any advice on gearing and tires?
Thanks,
Dillon Hoffman

OCRC SC10 set up

Proline Bowties
Gold/Silver springs
13.5
75/25 gearing.

Your money with this set up.