Hebiki

iTrader: (26)

Mike... spacers for split blocks.. .5mm spacers.. make it happen man!

cheehtae

iTrader: (15)

anybody got a good set up for 17.5, asphalt low grip.

Kody

iTrader: (9)

Thanks for the reply Mike. Wish I would have known about this a little sooner. I leave for CA this Friday and there isn't time to get it and install it. Unless Nor-Cal hobbies stocks them then its something I could pick up and install Sunday... Ether way I will pick one up at some point.

Thanks again

Kody

iTrader: (9)

+1

geeunit1014

iTrader: (14)

This is what I run. You can go 1.5/2 on camber if your wheel/tire will let you (ie no ring of death). I also changed to white/blue for springs, I like the feel better (more aggressive, I want to try the HPI springs soon). You can also go to 4mm on the front camber link if you want more steering

Droop is 2mm over ride height in the front, 2.5mm over in the rear.

On that note, I cant seem to remember, do we need any different shock ends or spring retainers to run the HPI springs?

CraigM

iTrader: (34)

No, the stock retainers are a little small but they work fine. FYI you haven't marked the droop on your setup sheet

Try the HPI springs, silver front blue rear for low grip

geeunit1014

iTrader: (14)

Thanks and thanks

cheehtae

iTrader: (15)

OK thanks. I'm going to try HPI springs too.

JasonC

iTrader: (120)

LOSI123

iTrader: (63)

Any one tryed the spec r gear diff in the rear with stock or super stock?

how does it hold up


also on website it says fit 416 & 416X

does it fit 416WE


Cheers

AZ416

it will fit the WE

im waiting on feeback from someone who is testing it in mod

M-Technic

iTrader: (15)

My friend and I will be running the Spec R gear diff tomorrow night, both in stock though. I will report back.

LOSI123

iTrader: (63)

Thanks Adam, keep me posted if you could, cheers

Ty

iTrader: (32)

Does anyone know if the 416X kit comes with the fluorine coated suspension balls? Thanks.

Stein Tumert

Mine did not...


...