Hot Bodies D413 1/10 4WD Buggy
#8461
ball cups
I broke a front ball cup. Are there alternatives?? B5?
Last edited by bladeys; 03-20-2015 at 06:34 PM.
#8462
Tech Addict
#8464
#8465
Time for major maintenance So I just decided to start with new Avid Chassis setup and go from there. Still too bad that all of this fancy upgrade stuff doesn't make me any faster.
Start with new Avid Chassis and Exotek center diff spur combo.
Add rebuilt front and rear suspensions.
Add electronics and Exotek wing mounts.
Rebuild shocks and add wing.
I run without the servo saver. I just found a servo horn in my parts bin that seems to fit perfect, cheap ProTek.
Ready to race, now to find the driver's zone that I have never been in.
Start with new Avid Chassis and Exotek center diff spur combo.
Add rebuilt front and rear suspensions.
Add electronics and Exotek wing mounts.
Rebuild shocks and add wing.
I run without the servo saver. I just found a servo horn in my parts bin that seems to fit perfect, cheap ProTek.
Ready to race, now to find the driver's zone that I have never been in.
#8466
#8469
#8470
can someone do me a favour and measure the width of the centre diff from bearing to bearing?
#8471
Well I got into RC cars a couple years ago at age 67, probably a little late to compete with the younger guys. But I have fun trying. I make them better, they have to figure out how to get past me every 3 or 4 laps.
#8472
Does anyone have a grass setup for this car?
#8473
Tech Initiate
Just bought this buggy and new into RC.
Any advice as to what is a good ESC/Motor combo for starters?
Any advice as to what is a good ESC/Motor combo for starters?
#8475
So just installed the exotek aluminum steering Ackerman. If you have not got the hopup, don't wait any longer. It took out a significant amount of play in the steering. Just be sure to not tighten the screws down tight as it will bind the bearings that come with the ackerman.