pkranger63

Well I took the plunge and just ordered a Barracuda from Speedtech. I got tired of switching my Xray between asphalt and carpet so I got the barracuda to run carpet. I am looking forward to running somthing diffrent than the TC3's and Losi's running at the track. Will be bugging you guys for advice shortly

elnitro

iTrader: (1)

Welcome to the club! I just hope Dave and Steve don't get tired of us new converts.

SpeedTech

iTrader: (5)

pkranger63,

Thank you for your order and we welcome you to the R2 club here on R/C Tech

elnitro,

I don't mind at all, it is my job The important thing with any new car is support, not just in parts, but also knowledge on building, setting up...etc. Only with these support will the car gain popularity, and actually, I should be thank you all for your support for the R2 so far.

Thanks again,

Steve Wang

elnitro

iTrader: (1)

Steve,
Well then, if you don't mind, please get back to work on updating your website for the R2 hop-ups. Some of us are really itching for those. Don't come back until you're done.

SpeedTech

iTrader: (5)

yes master, right away master...hahahahaha

I believe Alex racing will be soon releasing their own line of aluminum C-hubs, knuckles and rear hub carrier.

As for the titanium turnbuckles, we have them in stock, the complete set with the wrench (I'll get them online) Monday night is when everything should be on there. Ready to be shipped by Tuesday.

Steve Wang

MDawson

iTrader: (27)

You are lucky your cell phone is dead! I would be all over it with race updates!!!!!

Jeff Werner

iTrader: (30)

So did anyone get to run their new ride this weekend? I would think the reports will start to roll it!

Steve, how much of the servo Ears do you need to trim off for the servo to fit in the car?

Jeff

madjack

iTrader: (28)

Mr. Wang,

I wanted to ask if you had received the sway-bar sets yet? (Built the car with the short arms for So Cal)

BTW - spoke with Dave on my drive back Friday. He had his car in hand....looks we will both be running the Cuda this Tues. night

John

JDM_DOHC_SiR

iTrader: (31)

Hey Steve if those are the Same as the Speedway PAL one's then they are made by EXCEL Good stuff
-Dave

Macky

Here's a picture of the correct way. I was wide awake this time.

Macky

Here's a picture of the rear.

JDM_DOHC_SiR

iTrader: (31)

hahahahh I don't think so

-Dave

JDM_DOHC_SiR

iTrader: (31)

Looks Better Macky
...
BTW it looks like a close fit with the Turn buckle and Shock once it's attached to the upper deck , You should try to take a pic to see what I mean

-Dave

Macky

Yea Dave I placed the upper deck on and there is about 3mm clearence. I'll try and take some more pictures today.

JDM_DOHC_SiR

iTrader: (31)

You just need to trim off the top of the one mout ears that go under the shaft...not the whole side
-Dave