Originally Posted by Csaari77

Is everyone using the middle motor mount brace on the X? Are you leaving it off, or just inserting it and not tightening it down?

I'm about to start my build and haven't heard how people are using the 3 piece motor mount. The track I'll be running on is medium grip carpet.

Originally Posted by Cp Grafix

I got the tamiya gear diff, but I'm sick of the platic bevel gears

Does anyone know some metal bevel which will fit inside the case?

I have look at Hpi's hellfire bevel gear they have a 20t/10t also might fit.
Anyone know?

Originally Posted by Nilks

What is wrong with the stock gears? We can take a look at it next time at the track, if you want?

Originally Posted by rcguy48

What do you have to do to get the car to turn better in the corner?

Originally Posted by Csaari77

Is the setup from the IIC a good starting point for the 417X on a medium grip carpet track running blinky 17.5? It's really the only one I have been able to find for blinky carpet, but it's not for the X. If not, does anyone have any suggestions?

Thanks

Originally Posted by Nexus

Where you running? The Track?

There's a ton of us running Tamiyas. Stop over and we could look at it.

Originally Posted by RockyMania

Just want to double check with u guys the suspension hole position at the arm with reference to 417X setup sheet. Hole no. 1 is the outest for both front n rear, am i right?

Originally Posted by CraigM

Correct