Not a problem matt, give me a call tomorrow afternoon and I'll get everything lined up for you. Thx

Also a big Congrats to Kendall!!!!!
http://www.neobuggy.net/modules/news...p?storyid=7116

hey guys

im new to rc's probly roughly 6 months . had china cookie buggy that crumbled and got a decent one i just brought a go tech 5port for it.
have a few questions about the engine.

i used the heatgun on it and put foil round the head and it fired first pop but wouldnt keep running( very rich i think) i had to leave the glow ignitor on for it to keep running? is this normal?

also i was only using not even quarter throttle and thing looked like it would pull a tree stump out the ground. is it to lean? its got heaps of smoke splattering all over the joint tho so im confused!

everything is brand spanking new ive only ran 1 tank so far like that but wanted to get some advise b4 i keep going with it.


cheers brett

I will post the results as I get them... I have GX 5 and 7 ports to test, but no MG66 yet..... However hopefully sometime this winter one gets sent to me for testing.......

I'm really interested in the tire treatment stuff too..Can I get it shipped to France for a half reasonable cost? would want the combo pack..

GRIZZ mate i meant it in the nicest possable way

yep if you can spend others money well you are seen to be doing your best mate

U mean the video that shows a MG66 putting out about 6 hp Thats sick
Just search massivemods+dyno on youtube

ok heres the video , we have worked out why the reading was so high . the wheel ratios were double so the reading doubled ,, so the 6.4 hp reading was really 3.2 hp on that dyno .. we did 22 passes and they were consistant .. mind you we were running on 7% nitro

http://www.youtube.com/watch?v=nPxpTNsVjKA


MM

Let me do some checking on that for you. It would be worth it for you and some friends to order multiple bottles because of the shipping. Shot me an e-mail on my shop site and I'll let to know on the shipping. Thx
Troy

Mark is that with the Bio fule you were testing with ?

In my opinion, that video is pure BULL SHOT.
Until the MG66 gets tested on a, industry standard,
X-Dyno here in the U.S. and I see the real numbers
I will wait to buy one. Let the guys that live where
the weather is warm enough to race this time of year
buy them and give there reviews on it. Just wait until
the engine modding gurus here in the U.S. get a chance
to test and tweek the MG66. There opinions are whats
going to be the real test of the MG66.

dyno or not , these motors are bloody awsome in your buggy or truggy

I got a lot of explaining to do I told a lot of people about that dyno result u guys did

oops sorry for asking where the video was and stirring up some crap in the meantime
at least its all cleared up now

No worries mate , Cant wait to get a MG66 even when its not putti n out 6 hp

Lean out your low end until it will idle properly. You "may" have to richen up the high end just a tick if it is already clearing out when you give it throttle. Sounds like you are doing everything just fine. Make sure your temps stay above 200F so you dont develop slop in your rod. Good luck and have fun the 5 port is a power house.