Houstons Engine Service H.E.S.
#1262
Monty,
Nick took first place again Sunday. I had a servo failure early in the main and was sidelined because of it. I was running great though in the qualifiers. I didn't beat Nick but I was within 3 seconds on the fast lap. He wants to hook up with you before the ROAR race to race tune his car, He will contact you.
Nick took first place again Sunday. I had a servo failure early in the main and was sidelined because of it. I was running great though in the qualifiers. I didn't beat Nick but I was within 3 seconds on the fast lap. He wants to hook up with you before the ROAR race to race tune his car, He will contact you.
#1264
are you refering to the plus 2 367?
lots of rpm's , got to run a little stiffer clutch than most engines but lots of rpm's
pm's or emails for enquirys
gotta watch those mods ya know
#1266
#1267
#1268
#1269
#1271
Hello i have a novarossi 21-7 with a standard head button but i am having a bad time trying to tune it, dose some one have some needle settings to get me some where near a race tune?? Also what is the best pipe to run with this all i have at the moment is a nova 3005 and a JP-4 many thanks martin
#1272
Hello i have a novarossi 21-7 with a standard head button but i am having a bad time trying to tune it, dose some one have some needle settings to get me some where near a race tune?? Also what is the best pipe to run with this all i have at the moment is a nova 3005 and a JP-4 many thanks martin
try 3.5 turns out on low speed with barrel pulled out and 3.75 turns out on high speed
#1275
Hi Monty, quick question. When you do the R2R break-in, are the engines run until "the nuts drop"? Or should I expect "the nuts too drop" some time soon? I should have asked you over the phone when I ordered the engine.
thanx
chris
thanx
chris



22Likes