i assume the hub modification of you want it done do you need to take it to a machine shop to have done on a lathe ?

yep thats petty much the idea.
unless your a mad dog with a dremil like previously stated

i can get it done but you would need to send them to australia.

how many people are interested in having this done.
if there is enough interest in getting this mod done i might just go and buy a heap of them, mod them and sell them to those interested.
PM me if you want it done and ill figure out a price for supply, mod and shipping to america

tix im in australia im keen to get the mods done mate

I got mine in today and there was a nice piece of tooling included.
I bought it frome RCMushroom.

The truck looks very impressive Thanks Losi

mzl Hellsavage

Freekin Sweet.

That is cool. The only thing mine came with was a stripped rod end at no extra charge. I think I would have preferred the tool kit.

I bet if you call losi/horizon they will send them out. just say "What the Tooot....Why did buddy get a tool set and i didn't"....they'll say ok what's you shipping address.

I might have to do that! that tool kit looks pretty sweet.

i just called horizion and they didnt know what i was talkin about. they transfered me 3 different times to different people and finally transferred me back to product support and i wasnt waiting another hour before they talked to me again because there were 63 people ahead of me so good luck when u call about the tool kit

I haven't had a chance to take my 2.0 out yet, is there still an issue with the steering turnbuckles popping off?

Hi, anybody have an idea how to put the Mach 427 in the 8T 2.0. ?

you probably need to get a 1.0 rtr engine mount to install it in the 2.0

Not yet, they used a differant screw.

Is anyone else having issues with the cb/spur mesh? It almost seems like they are of 2 different pitches.

I have it, but still dont fit, The RTR have a space in the chasis to fit with the rotostart, but the TFT chasis dont. I think I will have to buy a backplate.