Guys check this link out, it will be good for a few weeks only or while supplies last !!!
http://www.kamikazercracing.com/prod...php?prod=51124

Team Kamikaze,

Just wondering what shipping service you use to Canada?

Last day I was trying to install Kyosho 2D on my JL but I've found a problem. the clutch nut is not as firm as was the 3D flywheel.. I mean I can move the piston through flywheel normally but when I was tighten I used the flywheel pin holder tool and Hudy tool.. I tighten and with the hudy tool I was moving the crankshaft too
I tried to place a tierap on exhaust port so its stop the piston and I can tighten but it broke and this can damage the piston
I was wondering if this tool here is for lock the piston in this case
http://rc-mushroom.com/product_info....oducts_id=3771
http://www.rcmart.com/catalog/produc...ducts_id=15649

Hi Guys,

does anyone now how much was the stock head shimms for the JLR red dot. Was it 0.50mm ???
thnx

two 0.2mm and one 0.1mm

thnx JEFF1,

If I remember right the engine comes %25 nitro ready, am I right*

You can choose either USPS Priority or Express Mail Service when ordeing from the website.

Yes, you are correct.

There must be something wrong with the Flywheel not matching the collet causing the crankshaft to still move while tightening flywheel nut.

Check the collet. I've had to sand them down as they are too long. When I tried to tighten the clutch nut the fly wheel was still loose. The nut was only hitting the collet and not the fly wheel. It's just some thing to check out.

Just got my red dot today and I am working on installing it in my serpent now.
The spacer that went between the front bearing and collet on my NR is the wrong inner diameter.
Do I find one the right size, or run it without one?

You don't need the spacer between the front bearing and the collet.

Thanks for the quick reply
Thanks to Kamikaze for the fast shipping to Canada.
The engine looks SWeeeeet!
Tonight is practice night, hoping to get it running and broken in and ready for raceday

Just bought the full kit from Sam at kamikaze. 2607 pipe, engine + manifold gasket. Even though i just bought a new engine last month, at the price your doing these, i couldn't resist.

what kind of plug did it have in it when I got it, the only marking was what looked like a 1 or an L ??
Engine started right up into a good raspy idle. taking it out to run a few tanks.....

yes i have tried that pipe but it doesnt work good with the header that come with it i used the header that comes with the 2607 mega pipe and man it really give the motor lots of power