18LikesXray NT1
02-20-2018 | 01:50 PM
#7532
02-20-2018 | 02:10 PM
#7533
Hey Jose. Doesn't RX8 also have flywheel slot on right side? Why would you have to move the rubber wheel?? You mean the the stoppers?
02-20-2018 | 03:14 PM
#7534
Tech Adept
Joined: Mar 2006
Posts: 223
From: Fullerton Cal.
Yes has the slot on the same side but more towards the rght to where you have to move the starter box wheel to accommodate it. You can used the same box but its a hassle to align fly wheels from both cars.
03-06-2018 | 07:05 PM
#7536
Hudy 106052
Recommend using grease on the pins as they don't wear as fast, but if you do this you will need to clean and grease regularly.
Recommend using grease on the pins as they don't wear as fast, but if you do this you will need to clean and grease regularly.
03-06-2018 | 07:16 PM
#7537
Tech Adept
Joined: Jun 2016
Posts: 201
Hudy 106052
Recommend using grease on the pins as they don't wear as fast, but if you do this you will need to clean and grease regularly.
Recommend using grease on the pins as they don't wear as fast, but if you do this you will need to clean and grease regularly.
05-08-2018 | 04:41 PM
#7538
05-08-2018 | 05:38 PM
#7539
We have on a 2014 model yes, sorry can't speak for any of the newer models though. Certainly alot cheaper then buying new drive shafts.
05-10-2018 | 06:59 PM
#7542
05-11-2018 | 04:36 AM
#7543
Tech Elite
Joined: May 2008
Posts: 3,478
From: Brisbane
07-07-2018 | 05:27 PM
#7544
Finally got around to building my nt1. Installing motor an clutch as to spec. Gears on pinion side are like 1 almost 2 mm off From being flush with spurs. Where should I shim behind collet ? Then re set all gap an end play Thx
07-08-2018 | 02:21 PM
#7545
pm sent