Guess I have to call tomorrow and add a couple leads for charging

SMC is awesome just when I started thinking about doing a saddle pack setup I see the square packs pop up on SMC website sweet deal too im so ordering one when they come in

Can you guys point me in the direction to a place that sells leads with the balance lead, that go from banana for the battery, to deans?

http://www.amainhobbies.com/product_...llet-Connector

Should have my two 5000mah 50C packs sometime next week. Excited to finally get some of the SMC koolaid

SMC sells them and alot cheaper than those ones from Amain

http://www.smc-racing.net/index.php?...product_id=108

SMC's are cheaper and the connectors fit better than the proteks

cheaper is not always better. the balance plug is too short on the smc. i would buy the a main one everytime.

It says pre order, any idea on when it will be in stock?

any issue charging at slightly below 1C? I am looking at getting at least one of the 6500 race formula lipos, however my current charger only charges up to 6amps. Would I see a loss in performance or any other issues? I would prefer not to buy a new charger anytime soon.

You will be fine. I charge my 6500 an 7200 at 5 amps even though my charger goes up to 6 amps. I've heard from many people that they charge at lower amperage. It's suppose to make the cells last longer but who knows if that is a fact.

I charge on an x4 that only goes to 6amps and run nothing but the 6500's. It may take a little longer but I don't personally have the need to pump 10+amps into the cells to get a faster charge. Good or bad I've had zero issues

im not a good enough driver to realize the benefit of charging at more than 1C. I charge my 6500's at 6amps. no issues

I have the x4 as well. Thanks everyone for the replies. I figured it wouldn't be an issue.

Any idea on when these will be in stock?