Nope!!!!! No motor mount!!!!!!! Put it in file 13, the trash can!!!!!

+1 on no motor mount!

LOSIRACER glad to see you kept the 8ight......I almost sold mine last week but decided to keep it and have two 1/8th buggies. Just added the EB48 to my stable.

MP

How do u like that eb48 compared to the losi??? But yes I just can't see getting rid of them and I will be going nitro also.

Does anyone know if the new Proline bulldog...

http://prolineracing.com/bodies/2012...r-body-8ight2/
or the new JConcepts Punnisher...

http://www.jconcepts.net/store/index...roducts_id=399

will fit on the 2.0e and clear the big 4s pack? Thanks!

Can anyone recommend a sensored motor for my 8, im using 4s.

Seen the lrp motors but these are big bucks! Any other cost effective motors out there??

I run tekin motor and tekin rx8 no issues. Running on 4s. Only problem i bought a 2250 kv way to Much motor. I didn't know at the time. I use it turned way down can make 15min main with 4s 5000 pack.

I use a Tekin RX8 as well with a T8 1700kv motor. It works great for smaller tracks and has plenty of power on a 4S lipo. If you run on a larger track, try a 1900kv motor. If you go with the 1700kv motor try 16/44 for gearing on the 8E.

I'm running the RX8/Tekin 1900KV setup on a 1/10 track that hard packed and gets dry and abrasive fast, especially in this heat. I'm burning through tires fast and wonder what most of you would use for a current limiter setting in this situation. I have mine at 80. There is an area where you have little room to get up speed to clear a triple so I need good punch but still think wheelspin may be adding to my fast tire wear. I am talking about 40 minutes and my soft compound tires are pretty much done.

I also run a RX8 and T8 1900 on 4s, I was overpowered before this setup and ran at the rear of the field, done about three meetings with the new compo and now win race's.

I have an old 8ight 1.0, just got the Tekno conversion and a 2.0 rear drive shaft to make a 1.5, are many running this setup?

Xerun 2250 sensored

Thanks for all the advice guys , Tekin looks the favourite!

Does anyone know if the new Proline bulldog body will fit my new TLR 2.0e...

http://prolineracing.com/bodies/2012...r-body-8ight2/

Thanks for any info!!!!

I have the 2200 xerun and it's a monster!

I mounted one on mine, I had to raise the body mount front and rear and left about an 1/8 of an inch extra on the bottom of the body, when I get it painted I'll post a picture.

Thanks a ton i look forward to it!